I lost my key to start my car

Call a mobile lock smith , they can reprogram the key

You seem to have very few options. You will need to see a dealer for a replacement ignition. Until then the only way to start the car is to hot wire it and I am not telling you to do so. You could do more damage AND if stopped by the police, they may assume the car is stolen. Better get someone to give you a ride to work.

Most often you need to get the computer reprogrammed. I hate to say this, but it would have been cheaper if you would have just called an automotive locksmith

Had the same problem and the motor is pricey. We went to a junk yard and found the same car and bought the door. We took it to a local small mechanic and he took the one and replaced it to ours. Never had another problem with the window, If you can find the same card in a junk yard it would be the cheapest way. hope that helps.

Sears automotive use to have the tool to take them off if the lock was lost,It looked like a socket and you just hammered it on then took it off with the impact gun.I have done this myself with a junk socket almost the size and hammer it on and use an air impact gun to remove it.

In my 2000 Bravada I went to the Olds/Gm dealer and bought it for $100. I went to junk yard after junk yard to find it but found out that it is very common for that bar to be rusted through. I even had to jack up my transmission just to get it in the correct way. I even went to the local Walmart and bought some undercoating kinda like rino lining. Took a full day to get it sprayed and really covered. The next day I was able to put it in. It is not easy to do but it can be done.

i have the 2.7 as well. mine is in an intrepid. Car was running perfectly fine when i went into bestbuy and when i came out 5 min later i tried to start the car and it would just crank n crank. no start though. eventually it started after lots of cranking. after a couple of times of doing this in order to start the car i would get nothing from the startrer. everything had power and everything electrical worked. found out that if i went under the car and hit the starter with a hammer a couple of times it would finally crank again. but i had to do this every time i shut the car off and wanted to start it again. i loive in WI and its wintyer right now so it really sucked to do this. took it to my buds shop and pulled the starter out and dissected it and found that the (i believe they are "brushes") were ground down to next to nothing, the positive ones, do to constant cranking. was going to get a starter from junk yard for 20 befor i knew what the problem was. did some calling around and found brand new brushes for $20.00. i just got those and installed them and had a good as new starter again. lots of dust to clean out of the housing though. brake fluid and air hose works wonders for that problem. but from best buy on the car would not start without starting fluid if it was at running temp. still yet to solve that one. replaced the cam sensor, crank sensor, plugs, COP's and checked the rest of the sensors. still cant figure this out. anyone have advice let me know what i can check. fuel pump kicks in wen the key turns as well...

yes if u buy ignition switch from the junk yard make sure they have it plug or u need to use the right key from the right ignition..
u cant use your own key sir u need the original key of the ignition switch where u took the parts.god bless

As long as they've (junk yard) got keys for it. Check auto parts places, for replacement, or dealer. You want the "ignition lock cylinder". If you need more info on replacing, let me know.

had the same problem. went to change the drive motor for it but found that there are drive gears in the steering column that were broke. replaced with a used one from junk yard, around $600