SOURCE: 2004 Chrysler Sebring Convertible How do I change the water pump
It is not all that hard, you can do it just get a haynes manual or any manual it will be very helpful and it away great to look at it when you doing the work. Have fun
SOURCE: 2004 Sebring needs new water pump and oil pump
$400.00, the mechanic had to pull the top of the engine off to get to the water pump. 8 hours later, they informed me that they never want to work on a water pump for crysler! Wait till you have to replace the battery.... gonna get rid of our sebring soon! Hope this helps...
Testimonial: "get rid of it, go to lawsiuts.com about flickering oil light and you will see engine failure is in the future... Sad so many people like me owe "
SOURCE: oil sending unit on 2004 chrysler sebring V6
Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove
SOURCE: Where is the fuel filter located on a 2004 Chrysler Sebring Sedan
Some of the Sebrings have two filters(one is called a sock).The sock(which all sebrings have) is located in the fuel tank itself on the pump module.If this model is the JXI then the external filter is located on the belly of the car between the tank and drivers rear seat. I hope I could help!!!
SOURCE: 1999 Chrysler Sebring Convertible code P1495. I
Code 1495 = Leak Detection Pump Solenoid Circuit
Remove the connector from the solenoid (should be on the back wall,
just to the drivers side of the air-hat). You will have the solenoid
to check and the harness. What you want to measure is the voltage
coming from the harness and the resistance of the solenoid.
Turn the
key to the "ON" position but do not start the motor; the voltage at
the connector should be at least 10V or more,.now, check the
resistance of the solenoid (should be around 35 ohms).
Hope helps.
466 views
Usually answered in minutes!
×