Is there vacuum line to winshield washer?

Don't be leave there is They have an electric pump to pump the fluid from the tank It should be located on or close to the tank

Find a heated garage, you need to thaw out he lines, or use a hair dryer if you can follow the line path. When working, drain all the fluid by holding down the spray button on the car. Go and buy he heavy duty washer fluid with the lowest freezing point you can buy and refill your washer reservoir with it. Don't add any water Most likely you had water in the reservoir and it froze.

1. Remove the left front fender liner.
2. Remove the air intake duct.
3. Remove the connector from the washer pump.
4. Remove the hose from the washer pump.
5. Remove the connector from the level sensor.
6. Remove the brake control module.
7. Remove 3 screws and the washer solvent container from the vehicle.
   
   Reverse to install.

PULL THE HOSE LOSE FROM THE PUMP. IF ITS PUMPING THEN THE LINES ARE STOPPED UP. IF NOT PUMPING THEN YOU NEED A PUMP

I hope it's only a bad vacuum line slipped off or broken, but it might be a bad vacuum motor. don-0hio (:^)

If pump makes noise we know it has power, first unplug the hose closest to the washer pump, if water squirts out you have a good pump, then follow the lines to the nozzles where they squirt out if all hoses are OK clean the nozzles most of the time they get clogged if it didn't squirt our replace the pump

Check and verify that you indeed have the winshield washer tank filled if the tank is filled make sure the winshield washer hoses are attached to the washer nozzles under the hood if all of this checks out you probably have a bad windshield washer pump...

Have you tried replacing the throttle positioning sensor?

THAT BLACK HOSE IS PROBABLY COMING FROM HOOD LINER,THATS A BROKEN WASHER SUPPLY HOSE FOR YOUR WASHER NOZZLES TO SPRAY WINSHIELD OFF. HOWEVER YOU PROBABLY HAVE ANOTHER SMALL BLACK LINE THAT GOES THROUGH YOUR FIREWALL BEHIND DASH RIGHT UNDER PASS SIDE AND VERY BACK OF ENGINE COMPARTMENT. THAT IS A VACUUM LINE THAT SUPPLIES VACUUM TO YOUR A/C PLENUM TO ALLOW MODES OF OPERATION TO WORK WITH YOUR MODE SWITCH TO DIRECT AIRFLOW TO FLOOR,VENTS ETC... THE LINE IS BROKEN,DEFAULT IS DEFROST AND THATS WHAT HAS HAPPENED.

can you hear the pump running.  If not check the fuses.  If you do and there is fluid.  Remove a hose from the back of the nozzle and se if fluid flows.  If so clean the nozzles with a needle as they plug up.