Where is the blower motor located - Cars & Trucks

Blower Motor Resistor

Blazer Forum https://blazerforum.com > forum > blower-motor-resis...
Oct 20, 2010 - The blower motor resistor is located under the hood on top of the HVAC housing towards the center of the truck. Run a search on "blower+motor+ ...

Can't locate Blower Motor Resistor on 1998 Blazer 4x4
Jan 11, 2012
2000 Chevy blazer blower motor won't work on high!
Aug 19, 2023
New blower motor,new resistor, no power - Blazer Forum
Aug 9, 2020
2000 Blazer - Heater blower Not Turning On
Oct 25, 2013
More results from blazerforum.com
https://www.google.com/search?q=2000+Chevy+Blazer+2WD+4.3+V6.+Blower+motor+resistor

The blower resistor in a Toyota Townace Noah with a 3S engine is typically located near the blower motor, which is responsible for directing air into the vehicle's cabin.
Here is a general guide on how to locate the blower resistor in a Toyota Townace Noah with a 3S engine:

1. Locate the blower motor: The blower motor is typically located under the passenger side dashboard, near the footwell.
2. Identify the blower resistor: The blower resistor is typically a small rectangular or cylindrical component that is connected to the wiring harness near the blower motor.
3. Remove the blower resistor: To access the blower resistor, you may need to remove the cover or the panel that covers the blower motor. You can then unplug the wiring harness and remove the mounting bolts to remove the blower resistor.

Note: The location and accessibility of the blower resistor may vary depending on the specific model and year of your Toyota Townace Noah with a 3S engine. If you are unsure about the location or how to access the blower resistor, it is recommended to consult a professional mechanic or the vehicle's owner's manual.
It is important to handle the blower resistor with care, as it can be easily damaged if not handled properly. If you are not confident in your ability to replace the blower resistor, it is best to seek assistance from a qualified mechanic.

The blower motor should be located under passenger side dash. The blower motor control module should be located close to blower motor.
I'd check voltage and ground at blower motor connector, hvac turned on. Purple wire is voltage. Black is ground. If good voltage and ground with no action from blower motor, suspect the blower motor.

UI would like to help but you have failed to provide the vehicle, make, model and year.

Here's a link to what your blower motor resistor look's like,it's next to the blower motor,2 screws hold it on.Blower Motor location can change from year to year. It can change with the trim level of the vehicle. A vehicle that has front and rear climate controls may be configured differently than a vehicle that has front controls only. The following are two different repair procedures. One is given because the blower motor is located and accessed in the engine compartment, the other is given because the blower motor is mounted inside the vehicle. http://www.autozone.com/cooling-heating-and-climate-control/blower-motor-resistor/duralast-blower-motor-resistor/cadillac/deville/1990/8-cylinders-3-4-5l-fi/860043_0_0 Here's a link to your blower motor. GET 35 GIFT CARD FOR EVERY 100 SPENT ON ONLINE SHIP TO HOME ORDERS

Its located under dash,or near glove box.

The dash panel lower side has to be out.

HEATER BLOWER MOTOR

Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.

It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.

=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

If you have a manual system, you have a resistor. If electronic, you have a blower motor speed controller. Please rate if this helps.

here is info:

Control System Outputs-Manual A/C
Blower Motor Switch Resistor
The heater blower motor switch resistor has the following features:

• The assembly is located on the evaporator housing in the engine compartment.
• Three resistance elements are mounted on the resistor board to provide four blower motor speeds.
• Depending on the heater blower motor switch position, series resistance is added or bypassed in the blower motor circuit to decrease or increase blower motor speed.
• An overheating protective device (thermal limiter) will open the resistor coil circuit when the temperature reaches 121°C (250°F) interrupting the blower motor operation in all speeds except HI.
• The thermal limiter cannot be reset and is not serviceable.

Control System Outputs-EATC
Blower Motor Speed Control
The blower speed control is located on the evaporator housing in the engine compartment.

• The function of the blower motor speed control is to convert low power signals from the electronic automatic temperature control module to a high current, variable ground feed for the blower motor (18527).
• The blower motor speed is infinitely variable and is controlled by the electronic automatic temperature control module software.
• A delay function provides a gradual increase or decrease in blower motor speed under all conditions.

Relays Blower Motor Relay(s)
The blower motor relay is located in the relay panel on the left front fender apron (16054). When the blower motor circuit is energized, the contact within the relay closes to complete the circuit for blower motor operation.

location is right side under dash , procedure is remove right sound insulator , disconnect blower motor connectors , remove blower motor cooling tube , remove the blower motor screws and blower motor , and reverse procedure to install .thanks.

if you locate the blower motor the rester is the wire that atachec to blower motor fallow wire till you find a circuit bord this is ur resistor