ABS, Parking break, and ESC light all stay on

You have a failure in your brake system.

The ESC light will go out when the ABS system is repaired. The skid may have damaged a speed sensor or some other component causing both lights to stay on.

use a scanner to reset the ecm program as removing the battery sometimes corrupts the CPU settings

abs will be abs sensor is in hub bearing.next is the engine code?

check for codes with scanner it most likely is the abs sensor on the rear differential housing that is bad easy fix

I HAVE SEEN A BAD BRAKE LIGHT SWITCH.CAUSE THE ABS LIGHT AND BRAKE LIGHT COME ON.WHEN SWITCH WAS REPLACE BOTH LIGHTS WENT OFF.

check your fuses. check your fuses. check under the hood on the top row there will be a 60amp fuse i beleive its the second one from the right it controls the abs system its blown. your probably gonna need a new altenator.

you have an abs fault. have your abs system scanned for codes.

your base brakes will continue to function normally

the parking brake spring might be getting week and not pushing it back into full release position and not alowing the park break switch to shut off and the abs light might be a brocken wire,if is a brocken wire usualy broken at wheel.Look behind each wheel and there should be a wire that goes to all four whells to see if any of them are broke or shorting out

There is a switch that should shut these off when the front door is opened. Have the dealer fix under warranty.