SOURCE: nissan sentra gxe 03 rear wheel hub bearing problem
Easy job ! just rem to get a gear puller for the antilock gear and install same as came off old one Parts around 100$ each apx 1/2 hr each side
SOURCE: what torque for rear wheel bearing Ford Focus 2000
Can only find out that the hub needs to be tightened to
235 nm Dunno if this helps
SOURCE: how do you change rear wheel bearing on a 2004 nissan sentra
Yes it is as easy as it looks. If you had the tire off and figured out that it looks easy, you shouldn't have much problem.
The bearings on the wheels has to be installed one way only, the rotor ring is built into the bearing and if installed the wrong way round the sensor cant pick up the wheel speed causing the ligt to be switched on in the cluster. The diagnostic equipment should pick this up as a fault once the car has been driven, it will see the sensor when you do the diagnostic if the car is standing still but once the car is moving and no signal is send from that wheel it would register a fault into the memory of the PCM that you would be able to retrieve later.
There is a way for you to test the sensor yourself by using a multimeter set on volts, you jack the vehicle up at that wheel, install a vehicle stand to support the vehicle to be safe, disconect the wheel speed sensor and probe the two wires into the sensor, spin the wheel by hand and a small amount of current will be produced meaning the the sensor is working and the wheel bearing is installed the correct way, you can also do a continuaty test on the sensor by switching the multimeter onto ohms, but be very carefull, if this sensor has three wires you cant do the continuaty test because of the integrated circuit in the sensor, the three wire sensors opperate on a voltage from 5Volt and it would be destroyed by the multimeter opperating on 9Volt.
If the continuaty test passes and the bearing is installed the correct way, the most comon fault would be a break in the wiring leading to the PCM
Hope this will be helpfull.
SOURCE: How do you reset ABS light\system after replacing
turn the ignition to on position and disconnect one of terminals of battery for 30 sec to one minute and reconnect battery . turn off ignition and restart vehicle . If that doesn't work go to dealer .
275 views
Usually answered in minutes!
×