Hi oricio martinez watson, I want to help you with your question, but I need more information from you. Can you please add details in the comment box? Is engine light on? if so you can take it by auto zone and they will scan it for free. need code, or more detailsHi oricio martinez watson, I want to help you with your question, but I need more information from you. Can you please add details in the comment box? Is engine light on? if so you can take it by auto zone and they will scan it for free. need code, or more details
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Clutch plate and pressure plate seem to be too weak to pull the car. To test the clutch plate, park the car on flat surface. Pull the hand brake up, start the car, depress the foot brake pedal, depress the clutch pedal, put the car in 1st gear, press the gas pedal and leave the clutch pedal at once, while keeping the brake pedal depressed.
Follow one of the two following statements:
1. Engine does not shut down and remain start. (Clutch plate, pressure plate and clutch bearing defective - Replace all as a set)
2. Engine shuts down. (Clutch system is OK and does not require any repair).
something wrong with the either teh stepper motor ofr the air flow meter ,best advice is to take it to a reputable garage and get them to plug it in a see whats wrong
You pinched the fuel line????
If you crank for too long to start the car, the engine will "flood", this is why the plug was wet. It had too much gas and wouldn't start.
Pull out ALL plugs and dry them off.
Install them.
HOLD your gas pedal to the floor and crank.
This will stop gas from entering the engine.
you need to get that extra gas out beofre it will start.
If you have so much gas in there you can do damage to your engine!!
Now after a few crnaking attempts with your foot to the floor, take your foot of the gas pedal and try to start it again.
But remember if it doesn't start in 3 tries, you need to do the pedal to the floor once or twice to remove the excess gas.
When you crank the car to start it sprays gas into the engine, even if it won't start. So it very easy to "flood" the engine, and then you'll have a hard time to get it going!
three possible answers to look at ; fuel filter located at the back drivers side by the tank; throttle positiion sensor or crank position sensor[ worst case scenario fuel. pump is starting to fail. gas or fuel filter first; bring the car to advance or autozone for a free scan for trouble codes
Hi oricio martinez watson, I want to help you with your question, but I need more information from you. Can you please add details in the comment box? Is engine light on? if so you can take it by auto zone and they will scan it for free. need code, or more details
×