Question about Cars & Trucks

1 Answer

Starts fine runs fine. After turned off, will not start. Wait or try again and it starts. What's wrong?

Check engine light is not on.

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 9,098 Answers

Car will sometimes not start after warm. - CarGurus

www.cargurus.com > Questions > Pontiac > Grand Prix

CarGurusJan 2, 2013 - When i start my car, for the first time during the day- I have no problem.... When I go somewhere and shut it off, sometimes it won't resatrt. ... I have to keep my foot on the gas and rev it up to keep it running- then it's fine. .... When your carstarts fine cold, then fails to restart while warm, it is usually a coolant ...

Blazer has to be jumped, then i shut it off and won't start.

www.cargurus.com > Questions > Chevrolet > Blazer

CarGurusDec 21, 2013 - I jumped it and it ran fine, but as soon as I turned it off I couldn't start it again. No clicking just like the battery is drained. ... Then run the car for ten minutes and shut it off and if does not start, replace the battery. ... Blazer starts fine first time but after shutting off,has hard time starting-takes up to 10 key turns or ...

Engine Performance Problems Due to Crankshaft Position ...

repairpal.com > Problems > Mercedes-Benz > ML320
"Crank no Start" Due to Failed Crankshaft Position Sensor on Mercedes-Benz ML320... It usually ocurs after I've turned the car off and try to restart after about 15 minutes. I typically allow it to ... fine. Stalling and starting problems intermittent at first, but now more frequent. ... Car runs fine then without out warning it won't start.

Posted on Jan 05, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 f150 turns over fine, at times wont run


When it won't start is there spark , does the check engine light come on when you turn the key on ? What's battery voltage at when it won't start , is the charging system working . When it won't start check power an grounds to the PCM/ECM - engine computer , your need a PCM/ECM connecter pin out .

Jan 22, 2016 | Cars & Trucks

1 Answer

What can cause your 1993 chevy caprice to lose power


run the fault codes first to determine the problem area

Jul 03, 2017 | 1993 Chevrolet Caprice

1 Answer

2004 Intrepid- when I start the car the RPM surges. If I put it in gear right away and try driving it continues surging down the street. If I start the car and wait like a minute before driving it usually...


The check engine light should be on and when it is the engine controls are in Limp mode. That means the computer is using a pre-set list of settings to try to keep the engine running long enough to get the car to a shop.
You need to get the problem with the MAP sensor fixed and get the light turned off.

Jul 09, 2012 | 2004 Dodge Intrepid

1 Answer

When it is cold it will start and run for about five minutes then shut off like you turned the switch off then it won't start again until it sits for a couple of hours. If I keep the rpm's up to about 2000...


First, if it is running that bad with the spitting and sputtering and all, the Check Engine light has GOT to be SCREAMING at you! If so, then that would be the first step. Get your engine computer scanned to find out why the Check Engine light is on.
If the Check Engine light is for some odd reason, not getting involved in this, I would still start with a scan and then watch the data stream to see what is going away to make the engine act the way it is. It sounds like you probably have a bad Crankshaft Position Sensor, but I would not go out and buy a new one before checking for other possibilities.

Please also review this article: What Else Could Be Wrong?

Apr 27, 2011 | 2000 Hyundai Accent

1 Answer

I have trouble starting my van and later on the check light came on (P1607). The car can no longer start but sometimes when I fiddle with the battery it would start up again and when it does it runs fine....


P1607 means "powertrain control module (PCM) internal circuit malfunction". According to the factory service manual, a low battery condition can cause this. This code can also pop up after the battery has been jump started.

You need to reset the PCM. To do this, turn the ignition switch off. Remove the No. 13 fuse (7.5Amp) from the passenger's under dash fuse/relay box for at least 10 seconds. Put the fuse back in. That should complete the reset.

Now to check again for the code: turn the ignition switch to on (not start.) Wait 30 seconds. If the check engine light stays OFF, turn the ignition switch off and wait 10 seconds. Turn the ignition switch back to on (not start). Wait 10 seconds. If the check engine light stays OFF, you had an intermittent fault and it has now been reset--everything is fine. If the check engine light comes back on during these checks, have the code that set read out. If the code is P1607 again, then you may have to have the PCM tested at the dealership for an internal fault.

Feb 04, 2011 | 2002 Honda Odyssey

1 Answer

Runs and stalls, wait for a min and runs again whats the problem?


well i would say if the rpm gauge stay's up and the other's all go down that would be a blown motor.

May 09, 2010 | 1999 Dodge Durango

3 Answers

I have a 2001 saturn sc1 that is having intermittent starting problems. At times after its been driven ill go out to leave again and it won't start. No clicking when I try and start it either. Wait for...


I am having the same problem. did you figure out what was wrong with yours. I have tested all of the wires in the harness under the dash, they r fine. I pulled off the starter and had it tested; O'rilies said it was fine. It is a 5 speed, and I can push start the car just fine any time. Like yours, some days my car starts, some days it doesn't. The days it starts, it runs fine with no problems starting or running. the problem is the days that it wont start.

Feb 25, 2010 | 2001 Saturn S-Series

1 Answer

1991 f150 when i first start it runs fine when i shut it off and


have the electronic module checked and maybe replaced to correct this problem

Nov 26, 2008 | 1989 Ford F 150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22423 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...