You will have to remove the steering wheel ( may need steering wheel puller after nut removed ) and the turn signal switch to gain access to a lock pin on the side of the key tumbler assembly , It will either be visible through a small hole or a very thin punch out in the face of the switch housing. push down on the pin and pull the switch straight out ( you need the key installed to allow this function , but as you said it is already there but broken off )
SOURCE: need wiring diagram for 2008 ford crown victoria
Hello,
You can purchase the wiring diagram for $5.99 from the following site: http://www.wiring-diagram.com/. You can also purchase a wiring diagram book from the following link: http://cgi.ebay.com/ebaymotors/2008-FORD-CROWN-VICTORIA-MARQUIS-WIRING-DIAGRAM-MANUAL_W0QQitemZ120394723100QQcmdZViewItemQQimsxZ20090320?IMSfp=TL090320147007r15080.
Hope this helps,
Chris
SOURCE: i want to recharge the air conditioner on a 1992 crown vic
find your evaporator inlet outlet lines on the fire wall usually near heater core inlet outlet lines. then follow both lines until you find the one that goes to the compressor. that is your low side and the port should be on there
SOURCE: how to trouble shoot starting system 98 ford crown victoria
Also check to see if there is power in the start wire form the ignition switch, the wire is a white wire with pink stripe, most likely not a common problem, but still something that could go wrong. this wire will feed the starter relay under the hood...
SOURCE: How to replace uppe ball joint in Ford Crown
First make an appointment for a front end alignment which will be required after replacing the ball joint. Securely support the vehicle under the lower control arm at the outer end, the end nearest the tire. The upper ball joint is attached to the upper control arm with 2 large nuts. Under the nuts are cams with hex heads for adjusting caster and camber. Mark the position of these cams in a way that will allow you to reinstall them somewhere near the same position. Next remove the outer end of the joint from the steering knuckle an then remove the 2 nuts and both cams from the control arm end. Reinstall and get that alignment asap !
SOURCE: 1992 crown vic 4.6l
Check the ground cable I had a bad ground on my 92 vic I replace the starter the battery then I found out the ground cable was bad replaced it and it starts prefect now
146 views
Usually answered in minutes!
×