2.8l. How do I disassemble the fuse panel? - 1991 GMC Sonoma

SOURCE: fuse for horn on 93 gmc sonoma keeps blowing

check the horns if you are short-circuited fuse burn

SOURCE: how do i replace a clutch master cylinder

unbolt and replace the unit. The secret is to bench bleed the unit before installing. Get a short section of hose, connect where the steel line hooks up, route the hose to the the reservior, fill with fluid and pump until bubbles disappear.

somtimes you can never get it working without pre bleeding, just do it, you will be much more successful.

Doc

Testimonial: "Thank You very helpfull indeed"

SOURCE: how to replace the exterior door handle on a gmc

You will need to remove the interior door panel,put the glass in the full up position,remove the rod attached to the handle(small plastic clip),using a 10mm socket and extension with ratchet remove the 2 bolts and remove handle.

Michael Schaffter

• 57 Answers
• Posted on Sep 17, 2010

SOURCE: 1991 gmc 1500 blower motor doesnt work

I had to change the blower motor, turns out the spring tension on the brushes on the motor were too tight and ate into the brass commutator of my old motor.

SOURCE: GMC 1991 2.8 Liter

The firing order for the 2.8 liter v6 engine is 123456. The number 1 cylinder is located on the left side and goes like this: Left side is 1,3,5. Right side is 2,4,6. The firing order on the distributor is clockwise and number one is located at the 7 o'clock position.