How to change a headlight in a 2005 ford focus zx4

Rob Sinbad

• 709 Answers
• Posted on Sep 25, 2009

SOURCE: broken rear wheel stud on a 2005 ford focus zx4 se

1. Step 1 Buy a new stud. Make sure you purchase the right size. If you're not sure what size to get, wait until you remove the stud and take it with you to the store.
   
2. Step 2 Check the area of the spare tire in the trunk for the jack and the jack tools since you'll need to raise the car to replace the wheel stud on your Focus. Be sure to block the tire diagonal to the jack.
   
3. Step 3 Use the jack to raise the Focus. Remove the wheel Take off the caliper and either hang it by a mechanics wire or lay it up so it doesn't dangle by the brake line. Remove the rotor. If you're working on back wheels, you have to remove the emergency brake clip first. You could have drum brakes in the rear. If they're drum brakes, remove the drum.
   
4. Step 4 Hunt for an opening behind the hub that allows you to remove the stud. Line the stud up with the hole. You may have to take off the hub and put it in a vise if you can't drive it out the back.
   
5. Step 5 Hit the stud with a mallet and drive it out the back of the hub. Push another stud into the opening. This is tough work, but you only need to push it far enough to thread on a wheel bolt.
   
6. Step 6 Put on a wheel bolt and begin to tighten it. As you do, the stud starts to pull through. Add more bolts as necessary until you seat the stud. Check in the back of the hub. When the head is flush with the stud, you seated it.
   
7. Step 7 Remove the extra bolts and reassemble the parts that you took off to replace the wheel stud on the Ford Focus. Put the wheel back on the vehicle and tighten down the wheel nuts.
   

SOURCE: I need serpentine belt diagram for 2005 ford focus

IF YOU GO TO ANY AUTO PARTS THEY WILL BE MORE THEM GLAD TO GIVE YOU THAT INFO. AUTO ZONE WILL DO THAT FOR YOU.

SOURCE: how do i clear fault codes in my srs module

with a scanner, no way to do it without the proper tools

SOURCE: what type of antifreeze is used with a 2005 Ford Focus

Hello mk12x.

Ford specification is Motorcraft Premium Engine Coolant VC-4-A (in Oregon VC-5, in Canada CXC-10) or equivalent meeting Ford specification ESE-M97B44-A (green color) with a mix of 50-50 coolant and clean water.
I hope your repair goes well for you.

Kl

SOURCE: how to remove the alternator

Its a big job and requires time, patience(try not to throw tools around), and following the step by step instructions from a Haynes/Chiltons manuals.
Good luck.