How to replace crankshaft seal and cam seal

Yes, it is possible for the ECU to be bad even if it is still providing codes to the OBD2 scanner. The ECU is a complex electronic device and it is possible for one or more of its internal components to fail without affecting its ability to communicate with the OBD2 scanner. In your case, the fact that the codes went away after replacing the #35 fuse and the IAC motor suggests that those were the underlying problems causing the "crank but no start" condition. However, the fact that the car still won't start after those repairs indicates that there is another problem, and it is possible that the ECU is at fault. To be sure, you would need to take the car to a qualified mechanic and have them perform a more thorough diagnosis. The mechanic may be able to test the ECU to see if it is functioning properly. If the ECU is found to be bad, it will need to be replaced. Here are some other possible causes of the "crank but no start" condition in your Lexus IS300: Faulty fuel pump Faulty spark plugs Faulty ignition coil Faulty camshaft or crankshaft sensor Low compression in one or more cylinders Clogged fuel filter Restriction in the air intake system If the mechanic is unable to find any other problems, then the ECU may indeed be the culprit. However, it is important to rule out all other possibilities before replacing the ECU, as it can be a costly repair.

SOUNDS LIKE IT MIGHT BE A BROKEN ROD .

Hi :)

Did you look on the back of the fuse panel cover for the fuse placement?

Here is a very usefull sit for you for conponet location.
http://www.lexuspartsnow.com/components/2001-lexus-is300~switch-relay-84-01-1609~2.html


If you need the PDF file email me at [email protected]

it is the only thing with an electrical wire running to it on the brake assembly usually on top of caliper should have plug somewhere on the line .Get the new one first and it will help you see things better.Should only need simple tools

Where is my 2001 Lexus is300 coolant sensor located at can write at [email protected] o can text 414-856-6955 I'll appreciate

PLS DO A COMPRESION TEST THEN YOU WILL KNOW IF YOU NEED TO REPLACE YOUR PISTONRINGS OR REDUE THE VALVE SEALS AGAIN

temperature blend door actuator is the name and the little plastic gears has wore out you will need to replace two choices the lexus dealer or salvage yard you decide

It caused by a faulty sending unit inside the gas tank or your fuel filter and or fuel pump needs replacing.

Good Luck!

back of light there is two bulbs they just twist out

Is the car lowered? mine does that too but is has 1.4 inch lowering springs. i readjusted the hight of the lights manually and they work fine now.