Where do you put the fuse for the cruise control.

Your owners manual should show you where the fuses are located. If you don't have an owners manual, you can go to
my.gm.com, type in your year--make--model and hopefully read your owners manual for free.
Do the brake lamps work ok?
I found these fuses, not only check fuses, check for voltage on fuse circuit, use a test light. Some fuses are hot all the time, some go hot with the key on.
Any codes for the cruise system?

Most Likely just a blown fuse. It's normal to put that on another system fuse, like the hazard or AC fuse.

The power for the cruise control comes through fuse #14 in the fuse box. From there it goes to the Cruise Control Switch. However, the Cruise Control Module is above the Fuse/Relay box, behind the dash board. Good-Day!

Hi Debbie,

First I think it should be said that whatever is wrong with your cruise control it is definitely NOT caused by a fuse. Fuses do not cause electrical circuits to fail. Failing electrical circuits case fuses to blow.

With that said, there are 2 fuses that affect your cruise control operation:
Fuse #6 (10 Amp) and Fuse #7 (15 Amp), both of which are located in the instrument panel fuse block. Fuse #6 is the power feed to the cruise control servo and Fuse #7 is the brake lamp fuse, which provides power to let the cruise control servo know when you have applied the brake.

i would look at the brake pedal sitch for chffed wires or shorted to ground

If you have identified that the fuse for cruise control usually it is under the dashboard panel in front of the driver. Size or ampere rating capacity is shown on the fuse itself.

Check that the cruise control module fuses are not blown in the fuse panel. Also make sure your stop lights are working; cruise controls are designed to disengage when the brakes are applied, and one method of sensing that is to monitor brake light current.


then reset your four wheel drive again

By removing the ABS brake fuse you are disabling other components as well. The ABS fuse supplies voltage to the brake switch that tells the ECM and ABS module the the brake has been applied. If neither of the modules can see the brake switch the cruise control will be electrically disabled. You need to reinstall the fuse.
Let me know.
Regards,