How to fix p0089 obd code on mitsubishi strada

Question edited for clarity.

I think you will find it is called 'Limp Mode'. It is the Engine Control Module finding a fault so serious that is might permanently damage the vehicle. You need to connect it to a Scan Tool and read the codes. The codes tell you the problem and the fix.

Limp mode

https://www.google.com/search?q=2014+volvo+s80+limp+mode

Complete List of OBD Codes (DTC') on Volvo Cars - Erwin ...

https://erwinsalarda.com > OBD DTC
Complete List of 2259 OBD Codes (DTC') on Volvo Cars. Accessing and erasing Codes. The engine control module (ECM) fault memory can only be accessed and ...

..

The Code won't Delete until you fix the problem. Clean or replace the EGR Valve.

Engine Trouble Code Error P0488 - PartsAvatar.ca

https://partsavatar.ca > Articles > All OBD Codes
P0488 is a diagnostic trouble code (DTC) for "Exhaust Gas Recirculation Throttle Control Circuit "A" Range/Performance". P0488 means that the powertrain ...
P0488 Dodge OBD Error Code: P0488 Lincoln ...
P0488 GMC OBD Error Code: P0488 Mercedes ...
P0488 Chrysler OBD Error Code: P0488 Lexus ...
P0488 Ford OBD Error Code: P0488 Mazda O...

P0488 - Exhaust Gas Recirculation (EGR) System Throttle ...

https://www.troublecodes.net > pcodes > p0488
Nov 18, 2015 - A stored code P0488 means that the powertrain control module (PCM) has detected a discrepancy between the actual position of the exhaust gas ...

VIDEOS as well

https://www.google.com/search?q=toyota+hiace+p0488

..

Replace fuel filters and check fuel pump pressure.

fuel pressure regulator
vacuum operated
on the Mitsubishi L200...vacuum operated
usually on the injector rail


The fuel pressure regulator is responsible for maintaining a steady fuel pressure.

Some vehicles have a fuel pressure built into the fuel rail assembly. Other vehicles with a returnless fuel supply,

the regulator is a part of the fuel pump module inside of the tank.



https://www.obd-codes.com/p0089

Did you read and clear the DTC after replacing the part?

Diagnostic Test Code (DTC) P1750 is a "generic" OBD fault code that is output by your engine control computer to let you know that the transmission control computer is reporting a problem with one of the transmission control solenoids. To find out the nature of the problem and which of the solenoids has the failure, you must access your transmission control module and retrieve the fault codes from there.

The transmission control computer outputs 2-digit codes that are not accessible by a generic OBD code reader.

DTC's (trouble codes) are 4 digits long. I am taking it that you mean P0401.Here is a link to a page that explains the code and the possible fixes:

http://www.obd-codes.com/p0401

P1000 JAGUAR - On Board Diagnostic System Readiness Test Not Complete, this is known as the OBD2 drive cycle.


Possible causes - The vehicle is new from the factory.
- Battery or Powertrain Control Module (PCM) had recently been disconnected.
- An OBD monitor failure occurred before completion of an OBD drive cycle.
- PCM Detected Trouble Codes (DTC) have recently been cleared with a scan tool.
When is the code detected? If DTC P1000 is triggered after DTCs have been cleared, all engine management OBD diagnostic monitor drive cycles have not been cleared. P1000 JAGUAR Description The On Board Diagnostic (OBD) monitors are performed during the OBD Drive Cycle. P1000 is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check.

The fault code relates to the fuel pressure sensor, it is either detecting low pressure, or is faulty.

It is most likely low pressure, either caused by an injector excessively leaking back through the leak off system or the pump is not pumping hard enough.

Start by getting a leak back test done on the injectors, and also a rail pressure test, if both come back as ok, then it is most likely the sensor that is faulty.

good luck

Locate the fuel pressure regulator. Check if its fuctioning. Hook up a fuel pressure gauge, and make sure it is within specification, if it is within specification, the fuel rail pressure sensor is not accurate and must be replaced.