How to repair not working rear lights 1997 gmc jimmy

SOURCE: set timing 1997 jimmy

Ok that's pretty simple Put cylinder # 1 on TDC= top dead center on the (compressionstroke piston all the way up). Mark on metal part of distributor (with marker) where the number one is on the cap( that's where the number 1 wire plugs in) Then in-plant distributor make sure that rotor point is pointed to #1 on the cap, turn distributor shaft until this is achieved or as close as possible try to center shaft so you can adjust... ****** or advance to fine tune after you in-plant distributor if needed. Contact if you need more help . Good Luck

SOURCE: how do you remove the third brake light assembly

You'll have to gently apply some prying pressure to the housing as you turn the screws, it sounds like they've stripped the part they go in...

SOURCE: 2001 GMC Jimmy break lights not working but all

Check the brake light switch should be a orange wire with 12v then a white wire with 12v when the pedal is pressed.If htat cks good then ck the hazard switch by moving it up and down and wiggeling the knob with the brake pedal pressed if they start working then your multifunction switch is bad and needs to be replaced.

Testimonial: "We check and you were right on the money. It's the hazard switch carrier. Thanks for you help."

SOURCE: replace water pump on 1997 gmc jimmy 4.3 litre

there are four nuts that you must remove at the front of the pulley between the fan. remove fan, fan shroud,loosen accessory belts. remove water pump pulley and the pump bolts will be exposed. check belts for replacement while you have them loose. reverse procedure to install.

SOURCE: 1997 GMC Jimmy- When the

you most likely have a rear wiper ? there is a problem with the motor or the linkage take the rear hatch interior panel off and you should be able to see the problem

Testimonial: "Thanks for the help"