My flasher relay located on my 1987 Nissan hardbody

old marine

• 2426 Answers
• Posted on Jul 25, 2008

SOURCE: troubleshooting air conditioner thermostat 1995 nissan pickup hardbody

The thermostat is located where the lower radiator hose goes into the engine. I've had to replace mine, and it took a while to find it. I found the easiest way to get at it is to remove the power steering pump (hoses attached) and set it over to the side to get at the bolts on the thermostat housing.

Good luck!

SOURCE: i have an 1987 nissan

Have the Mass Airflow Sensor checked (it's the black, plastic box the size of a business card on the driver's side of the throttle body). It is VERY common for them to give false readings to the ECU.

ZJ Limited

• 17989 Answers
• Posted on Nov 09, 2009

SOURCE: where is the flasher relay located for 1998 Toyota 4- Runner

Toyota Pick-ups, Land Cruiser, and 4 Runner 1997-00
Flashers -REPLACEMENT

The turn signal flasher is usually located in the convenience center, under the dash, on the left side kick panel. In all cases, replacement is made by unplugging the old unit and plugging in a new one.

Hope helped with this (remember rated this help) Good luck.

SOURCE: Where is the flasher relay located on

Where is a flasher relay fitted on a 1999 Mondeo 2l ?

SOURCE: 1998 Dodge Durango flasher relays location

Turn on the Durango and check each of the four turn signals to make sure that the bulbs are not burned out. If you find one that has gone out, replace the bulb and retest the turn signals. When a bulb goes bad on this circuit, the resulting operation can mimic a bad flasher or one that is failing.

Locate the combination turn signal flasher and relay. It is on the left end of the driver's dash. Open the access door and view the collection of relays and fuses. At the left side of the mounting block is a larger flasher and relay. This is the combination turn signal flasher and relay.

Test the relay by placing you finger on the relay housing and activating the turn signal. If you have found the right one, you should feel a clicking as the turn signal blinks. Remove the relay, replace with the new relay and close the access door

.

Start the Durango and activate the turn signals to check that they each work. The light should turn on and should blink. Also, check the hazard lights to make sure they work.