SOURCE: Transmission filter replacement 1999 oldsmobile intrigue
25 ft pounds is pretty commont on trany pans.
SOURCE: AWD on 2003 Oldsmobile Bravada
possibly, but the most common problem is the engagement motor located on the rear of the transfer case. Motor looks like small wiper motor and can be replace fairly easily.
SOURCE: Need infor for Oldsmobile Bravada 300 SUV R&R front differential
This is a HUGE job that will require mechanical skills and a goo repair manual. This question can not be answered in it's entirety in this post.
SOURCE: THE TRANSMISSION WENT OUT ON MY 2000 OLDSMOBILE
See if the speed sensor is unplugged on the transmission, if its not replace the speed sensor.
SOURCE: how do I bleed my
This job is a lot easier with two people but you can do it with 1 if you have to. Have someone sit inside and pump the brakes 3 or 4 times and on the 4th pump hold it to the floor(all the way to the floor and don't let up at all). While they hold it to the floor you take a little end wrench and (Starting on driver side front going to pass. front next then pass. back and so on) you should already have the tire off before pumping brakes. On the caliper(the thing that holds the pads) there is a little bleeder nut Should be near where your brake line goes into the caliper. Now while they hold the pedal down you loosen that nut just a little bit and it should spit a little bit then maybe some fluid will come out maybe not on the first time but it does happen. Just dont leave it open longer than a couple seconds. Just long enough for air to escape then tighten back down. Repeat all those steps about 4 or 5 times for each tire or until brake pedal feels hard to push in. Make sure while your bleeding that you check your master cylinder often if you let it run out u will have to start over from the beginning. Also make sure who ever is holding the pedal do not let up when bleeder valve is open. Same thing. I just wantedn to m
147 views
Usually answered in minutes!
×