How do you reset erre for radio on 2004 acura?

The numbers on the radio screen after pressing 1 & 6 are the serial number to retrieve the radio code!

The 4 digit number on the glovebox is probably the radio code, keep pressing preset number 1 until the first number is on the screen, then press preset number 2 until the second number is on the screen, then press preset number 3 until the third number is on the screen, then press preset number 4 until the fourth number is on the screen!

Enter the lock code; sometimes is in the last pages from owners manual; if not, must visit the dealer with the VIN number and ask for this. The lock code is unique for each vehicle, anyone could sell you for internet.

Hope this helps.

Look for the code on the outer left side of the glove box, top number is the code, the bottom number is the serial. Just saved you some time and money. Now if you could explain how to get the radio to prompt code entry instead of error. Tried removing fuse under the hood and disconnecting the battery terminal to prompt code entry, to no avail.

Disconnect battery for about 20 seconds. When you reconnect it, you will need to enter your code for the radio. If you try and fail three times, you get that code.

take it to an acura dealer and they can unlock the radio for you if you don't have the code.

err-3 means you have entered incorrect anti-theft radio code more that three times.If you do not have radio code you can most of the time find the code card tucked away in the owners manual pouch.(looks like a bussiness card)If you are unable to find card you would have to pull radio from dash and retrive stereo serial number,which is on bottom side of radio.once you have s/n you can take s/n to any acura dealership(has to be a dealer)and they can get radio code for that stereo through Honda Corp.once you have correct radio code you will need to first unplug radio,or disconnect battery to reset radio memory,then type in radio code.again if entered incorrectly 3x ,radio would need to be reset again too clear error codes.good luck!

We had the same problem. As advised from another website, we unhooked the battery and hooked the cables together for about 10 minutes. This reset the radio and allowed us to put in the 5-digit code. Now we're jammin'!

ok your radio displays ERR , OK 3 options let it sit for an hour turned on , to reture to CODE display , or pull the radio fuse out for a minute and put it back in , returning to the CODE display , or disconnect the battery for a minute , returning to the CODE display . you got the ERR display because the code was wrong or not entered correctly , make your choice of getting the radio back to the CODE display by 1 of those 3 choices , while the radio displays CODE , use the preset buttons , if the first number of your code is 4 , then press the #1 preset button 4 time , when the first number has been input , put the 2nd number in by pressing the #2 prest button , if 2nd number of code is 8 , press the # 2 preset button 8 times till the # 8 is displayed , and so on . you see where this is giong ? when you have entered all the numbers correctly you will have you radio back . when you say you have the radio code , good luck ! were rooting for ya .

J5

you need to take the neg (-) battery cable off to reset the radio. you can only enter the radio code 3 times incorrectly than it will lock up. i think you can pull the back up fuse from the under hood fuse box for 10 seconds and that will also reset it.

Check any documents you have for the car and look for a card that came with it when it was new. It will have an anti theft code on it. If you find it turn the key on in your car then with the radio on use the station preset buttons to enter the code. If you dont have the code then take your car to an acura service department and they will give you the code after verifying its serial number.