Transmission was fine before booster replacement.
SOURCE: My brakes will tighten up
try replacing the check valve in the brake booster vacumn line see if it helps you can test it first by blowing in it, you should only be able to blow in it 1 way but not the other
SOURCE: replacing a brake power booster
you need to be bendy to get linkage undone under dash at pedals..remove brake master and away..unbolt booster and away you go..good luck
SOURCE: replacing power brake booster
You don't need to remove the pedal to get the booster off,it just slides inside,so when the booster is unhooked it will just pull out.
Please rate this a fixya.
SOURCE: replacing my brake booster
go to the master cylinder and remove it from the booster, disconnect the vacuum line from the booster, then disconnect the brake plunger from your brake pedal inside the vehicle, then remove the booster mounting bolts from inside the vehicle then remove the booster, install in reverse order, once you install the master cylinder, you will need to bleed out any air in the brake system, hope this helps, let me know
SOURCE: brake pedal dropping to floor
do u have the antilock brake bleeding tool? if not you will need to have the dealer bleed the brakes, the ABS control valve must be electricaly held open to bleed the brakes there of course is a special tool for this.
Testimonial: "Thank You"
110 views
Usually answered in minutes!
×