2000 HYUNDAI ELANTRA SERVICE REPAIR MANUAL DOWNLOAD
to fix your car go to this link
SOURCE: 2000 mercury mountaineer power windows won't work
check for a broken wire in the wiring between the body and door
SOURCE: how to remove the drivers side and drivers side
Very simple!
Simply remove any exposed screws, and, using a tool from any automotive store (looks like a flattened out screwdriver with a slot on the end), and use it to pop the panel off. Remember to remove any wire connectors to the switches. Same for the rear. Installation in revers order......sounds harder than it is but it is really easy.
Take your time and take pics with a digital camera....too many pictures after each step is better than not enough!
SOURCE: Remove a driver side door panel on a 2000 Toyota Limited 4 Runner
remove the screws that hold the inside door handle and clips behind the door panel
SOURCE: Problem with door locks on 2000 Ford Windstar. You
You need to get a can of penetrating spray (WD-40) or similar, and spray inside the lock/latch mechanisms. Use the little red nozzle and make sure you get in behind it, down the side etc, to loosen up linkages. It may take a little work, and a couple of sprays, but keep working them manually until they free up, then start using power locks as well. Once they are working good, get a spray can of white lithium grease or similar, and give them a coat of that as well, sprayed all over the backside, and down the sides as well, to prevent/deter same happening again.
SOURCE: how do I remove driver side door window
You need to remove inner door panel by unscrewing the screws on inner door handle and take a flat screw driver wedge it between the panel and door use flash light to see the clips along the sides and lower part of door and pry them free. then look through the inner door cut outs to find window track. Once you see it use ratchet or screw driver and loosen the window free form track. Then carefully remove window.
151 views
Usually answered in minutes!
×