2001 acura mdx runs fine but no passing power

Question edited for clarity and spelling and toss in some CAPS!
Question moved to model category.

It appears to be a known issue

https://www.google.com/search?q=2001+Acura+MDX+gauges+not+working

Exhaust and Emissions Auto Parts for your ACURA MDX

this may or may NOT help please let me know.

2001 Acura MDX Repair Problems Cost and Maintenance

http://www.mdxers.org/forums/73-2001-2006-acura-mdx/47786-mdx-transmission-rear-main-seal-diy-tutorial.html

Acura?
both sides are missfiring
ever give it a tune up? the 60,000 mile?a
spark plugs, filters. even new COP boots?
compression all good.
fuel pressure at spec. and injector leak down pass and balance test
stated in the FSM?

Check this website - you find there fuse box diagram and description for Acura MDX (2004)

Acura MDX 2004 fuse box diagram Auto Genius

On this website you find fuse box diagram and description for Acura MDX (2001)

Acura MDX 2001 2002 fuse box diagram Auto Genius

Here's an excerpt from the 2002 Acura MDX 4WD 6cyl Repair guide for replacing what the reference manual calls the "control assembly" - its located under the console rear trim and may (or may not)
contain the blower resistor - my manual doesn't say - but this is the closest thing I could find for you. Every other blower resistor I've had to find was located close to the heater controls - and this
car seems to be no exception -- its heater controls are located in the console between the seats, rather than in the dash (as in Acura 2003-06 MDX models).

You may want to call your friendly Acura dealership ad speak to the parts department, to make sure where the blower resistor is located - or a visit to a dealership parts counter often (or
Advance Auto Parts is helpful too) ofen clarifies questions I have from Haynes manuals (the cheapest car repair guides).

All this assumes that you've correctly diagnosed your blower control problem -- as in "replace the blower resistor when the blower works only on the MAX/Highest setting."

-- begin excerpt from 2001-2 Acura 4wd 6cyl MDX Repair manual --
Control Assembly Removal & Installation

2001-02 Models

1. Remove the console rear trim. Refer to the accompanying illustration.
   
   

   Fig. Exploded view of the console rear trim
   

2. Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B).

To install:

1. Install the control unit in the reverse order of removal. After installation, operate the control unit controls to see whether it works properly.
2. Run the self-diagnosis function to confirm that there are no problems in the system.
   
   

   Fig. Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B)
   



--- end excerpt from 2001-2 Acura 4WD MDX 6cyl Repair Manual ---

Immediately take your car to a dealership. You run the risk of a major catestrpohic component failure. I wish I offer you a better alternative. Best of luck!

Check you switch, resistor (if so equipped), and wiring for a bad connection, corrosion, or short.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

you may want to check the ground wire for the engine; if the car just shut down it's possibly an electrical. if the ends are corroded replace.