Waterpump what's the torque specs for putting on a brand-new one how many foot pounds

Hi Joe

51 foot pounds

2000 Toyota solara 2.2L Engine Torque Specs

https://toyota-specs.com > cars > torque-specs_engine

Toyota Camry Solara Alternator Torque Specs : 18 ft-lbs ; Belt Tensioner Torque Spec, 51 ft-lbs ; Motor Mount (Engine Side) Torque, 59 ft-lbs ; Motor Mount (Frame ...

according to the manual (Chiltons).
#1 YOU MUST USE NEW ROD BOLTS AND NUTS !!!!
#2 TORQUE TO 17 FOOT POUNDS !!!!
#3 TORQUE TO 32 FOOT POUNDS !!!!
#4 TIGHTEN AN ADDITIONAL 90 TO 120 DEGREES !!!!
#5 DONE.

start with 15 foot pounds, then 30 foot pounds, then 45 foot pounds, then finally 65 foot pounds, all the while bolting them down in a clockwise pattern working from the center out with each setting of foot pounds.

About 42 inch pounds... Inch, not foot. 42 foot pounds will strip the threads. 3 and 1/2 foot pounds.

About 42 INCH pounds are good for these.. INCH, not foot. 42 Foot pounds will strip out the threads. Your torque wrench will not go to 3 and 1/2 foot pounds.

cylinder head and main bearing bolts had a first step torque of 50 to 60 foot-pounds and a second step torque of 80 to 90 foot-pounds each. The rod bearing bolts had a first step torque of 25 to 30 foot-pounds and a second step torque of 30 to 36 foot-pounds. The intake manifold and exhaust had a first step torque of 5 to 7 foot-pounds. The intake manifold had a second step torque of 14 to 21 foot-pounds while the exhaust manifold had a second step torque of 16 to 23 foot-pounds.

BMW PARTS

The foot pound torque is 100 foot punds for the lug nuts.

call auto zone ask for torque specs

Hello vienotkelly: The correct Main bolt torque is 42 foot pounds. The connecting rods torque to 29 foot pounds. The torque sequence for the head bolts and the correct way to tighten the bolts are attached to this reply. Thak You for using FixYa. Roger

Head Bolt Torque For your 1994 Oldsmobile Cutlass Supreme (3.4L SFI DOHC): Foot pounds (Final torque) Note: Torque sequence --------- | 6 2 3 7 | | 5 1 4 8 | --------- Step 1: torque in sequence to 33 Ft/Lbs Step 2: turn an additional 90 degrees Recheck final torque in sequence *** CAUTION ***engine uses Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque. Foot pounds (Final torque) Note: Torque sequence --------- | 8 4 1 5 | | 7 3 2 6 | front --------- of engine | 6 2 3 7 | | 5 1 4 8 | Step 1: torque to 40 Ft/Lbs --------- Step 2: turn an additional 90 degrees Recheck final torque in sequence *** CAUTION ***engine uses Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque.