Save your money, the chip is a ohm resistor at Radio Shack for under $2.00. It splices in to you IAT wire harness located at the intake tube between the air filter housing and throttle body.
Problem with this system is, that you can not adjust anything and have to run a constant 91 octane just to make sure you do not have a Detonation. The ECM will catch the Detonation from the knock sensor and compensate for it by retarding the timing which in turn lose of HP till next start up.
If you like and don't mind the check engine light on once and awhile, you can do the same by just disconnecting the IAT wire harness which give the ECM a 0 resistance thinking it's -20 out side and turn the timing up and lengths the injector pules.
When i was running a Nitro in the Toy before i sold it, i had installed a 10K ohm Potentiometer which you can buy at radio shack for under $5.00 i believe, I just spliced it in to the IAC wire harness so if i wanted to play with the Nitro I'ld turn the resistor up making the engine think it's 185 degrees F and would ****** the timing so i would not hurt the engine. But if i wanted to get more timing i would just turn the knob to drop the resistance to get more time since the engine thinks it's -20 out side.
Hope this helps. Keep me posted if you need more info. Best thing is to do a dyno tune and you can change everything right down to the Shift points.
SOURCE: How do I install a performance chip for the IAT.
that "performance chip" is not good for you car. that resistor is trying to make your car think the air coming into the intake is colder than it is, thus making your car use more fuel to perform better. slightly feel like more horsepower, use more gas.
SOURCE: I Want To Install A
Hi Please check this article to view the article
thoroughly to get an in-depth knowledge related to your query. Hope it will be
helpful. http://qcwo.com/technicaldomain/iat-resistor-mods-vs-performance-modules-vs-real-chips Please get back to us if you have further
query else please accept the suggestion.
Thank you for contacting fixya.com
SOURCE: I want to install a Tunesport module in my 2000 Acura 3.2 TL. Which wires do I connect to?
That is not a chip (it is a 50 cent resistor) and it will void your warranty and likely damage the engine as well.
SOURCE: Need IAT/MAF wiring diagram for a 2008 5.7 liter Toyota Tundra
go please to www.autoelectronico. com and download for free. this web is spanish . However you can translate the information. I strong recommend you by powerful information update for any models cars.
Try it and fix it for FREE.
God bless you
272 views
Usually answered in minutes!
×