How do i reset my factory alarm - 1999 Ford F250 Regular Cab

not sure if your having problems with factory alarm but if it is malfunctioning it most likley will again so here it goes...... to reset alarm insert key in drivers door turn key left then turn key right this should disarm and reset the factory alarm. to disable the factory alarm for good in the drivers door wireing harness look for the factory alarm disarm wire it should be dark green/purple with a negative polarity when your sure you have this wire splice a wire of the same size into it and ground the other end to the frame make sure that you have a good solid ground here and thah where you spliced into the wire is a good connection. this should terminate the factory alarm function hope this helps you

If the alarm system has a battery remove it otherwise removing the car battery for a while may reset it. In emergency contact your local toyota dealers mechanics department and they may be able to help you at no cost.
If you put a general enquiry on google you might get lucky, do not be too specific. i.e. toyota 1994 alarm reset procedure

Hello. Alarms are a pain and can cause problems. The best thing to do is disconnect the fuse for the alarm in the fuse panel of the car, then the alarm will not work at all. Also becarefull that it does not cause problems to the car itself. Good Luck.

Most factory alarms reset when key is turned on. Remotes are available through the factory still bought by VIN #

to disarm the factory alarm try unlocking driver door with the key. does it blow the horn or does it have a siren?

lock your doors and close it wait till alarm resets and then unlock door with key and this should take care of you problem

factory alarms do not need to be reset.. if a problem cycle key in drivers door lock then unlock a few times// that manually sets and deactivates factory alarm

you HAVE to get a remote and unlock the car.the dealer may be able to turn it off with the obd2 system,you have to call subaru.

Hey my friend, All you have to do is put the door key in the passenger side lock and turn it to the right. This will reset the factory alarm.
George.

the only way to reset an alarm is to disconnect the battery cables.

there is no such thing as an alarm reset switch.

My suggestion would be to go to autozone, they sell replacement key pads.