SOURCE: fob will not unlock/lock doors 2007 dodge ram,
fob broken or bad, or fob battery bad, key problem not reading key code
SOURCE: 2001 Dodge Ram 1500; how to reset computer after replacing dead battery
disconnect the positive battery cable for 2 minutes and that will reset the computer
SOURCE: reprogram 2005 Dodge Durango key fob
Go to the dealer. It is the only way, they have to use a computer. Changing the battery doesn't make it lose it's program though. You most likely broke the battery hold down. This is the most common thing I see at my shop. If the key still starts the vehicle, you now have a bad key fob. If not, you may be able to get it reprogrammed.
SOURCE: alarm went off and key fob quit working
start the car. if that dose not work remove ground form battery then after it stops put ground back on that will reset the alarm.
Testimonial: "started the car, shut it off and the alarm quit. But now none of the features work on my key fob."
SOURCE: i turned the key to my 2001 dodge ram 3500 and it
A code P0500 may mean that one or more of the following has happened:
1.The Vehicle Speed Sensor (VSS) is not reading (functioning) properly
2.There is a broken/frayed wire leading to the vehicle speed sensor
3.The vehicle's PCM is not correctly configured for the actual tire size on the vehicle
The simplest thing to do is to reset the code and see if it comes back. Next, check all wiring and connectors that lead to the speed sensor. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, transmission, or perhaps the wheel hub (brake) assembly. If the wiring and connectors are OK, then check the voltage at the speed sensor.
P1693 (M) DTC Detected in PCM/ECM or DTC
Detected in ECM
A 9Companion DTC9 was set in both the ECM and PCM which is related to the above DTC code.
1,728 views
Usually answered in minutes!
×