SOURCE: Brake lights not working when you apply brakes
check the brake light switch.
It's usually up under the dash, and it activated by the brake pedal.
There are 2 wires going to it. To test it, jumper across the leads.
or, watch the "action" sometimes you just need to reposition the switch to get it to work.
SOURCE: Brake? Problem with 01 Saab 9.3
to begin i dont know what it means to say expensive or not how ever, all the lights at the same time could only mean one thing the problem could be in one of the diodes in your alternator is bad thus turning on all the lights on the dash board,
now regarding your brakes especially on saab;s shake or vibration is caused by uneven surface on the brake rotors (usualy the front) my suggestion is to replace the front rotors and the brake pads at the same time.
SOURCE: Brake lights wnt wrk when pushing dwn brake, but park lights do
As cadman mention to check the fuse, and if there ok check your brake light switch along the brake peddle arm. Before you doany of that, turn your hazard light on to make sure that all your light's are not burnt out. Good luck
SOURCE: TURN RT APPLY BRAKES ABS/TRAC OFF COMES ON
bad front bearing/abs sensor The sensor is part of the bearing,or the wires are bad so that when you steer it open circuts and thinks the wheel is stopped. need to read codes or use a scan tool with live data to see which wheel the computer thinks is stopping. then look at that wheel for problems
SOURCE: Parking Brake Fault
This is a common fault often caused by low battery voltage, before you start taking expensive actions with the park brake modules etc get your battery checked for 100% efficiency.
Hope this helps, good luck.
148 views
Usually answered in minutes!
×