FORD EXPLORER XLT 1992 parts diagram

The purge solenoid on a 2006 Ford Explorer XLT is typically located near the engine, often near the fuel tank.
To locate the purge solenoid:

1. Pop the hood and locate the engine.
2. Look for the fuel tank, which is typically located near the rear of the engine compartment.
3. The purge solenoid is usually located near the fuel tank, often on or near the fuel lines. It may be mounted on a bracket or attached directly to the fuel lines.
4. If you are having trouble finding the purge solenoid, you may want to consult the vehicle's repair manual or a diagram of the fuel system. You can also try searching online for images or diagrams of the purge solenoid on a 2006 Ford Explorer XLT.

http://ww2.justanswer.com/uploads/wmarti7/2011-03-09_113550_92_explorer.jpg

What Diagram do you need?

I don't know about the auto hub parts, but I know repair diagram at http://www.obd2express.co.uk, you can view it for many kinds of auto diagnostic tool.

I have enclosed two wiring diagrams, one is for base radio and the other is for premium radio.the way to know which one you have is that the base radio does not a have an amp connected to it. you will see it in the wiring diagram.hope this is helpful. good day.

You need a NGS (Ford factory scan tool) They can access the RAP KEYCODE PID.

Heres the definitions of the fuse numbers:

here is the specs. on your ford.The Ford Ranger 4.0L Engine - The Ranger Station

try going to real auto parts store not some chain franchise like pepboys or autozone ,with bolts means studs to a ford which will be a rotor with hub unit,and if it has just has holes then it's a slide on rotor or it needs to be pressed to your hub assembly,just go to a small parts store with someone who knows the difference,,2wheel or 4x4 makes all the difference.

usually on fords the inertia switch is on the passenger side up under the dash on the firewall, not positive on the explorer but on other fords i have worked on that is the location.