Question about Lexus Cars & Trucks

Open Question

How do i install a headlight housing assembly on my 1990 ls 400

I have just bought a used 1990 lexus ls 400. although the headlights work, they are pointed at the ground. i;m trying to locate the little parts i.e nuts bolts screws that go into this subassembly. Can U Help?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: can't adjust 2004 Ford Expedition headlight

I had a similar problem on my 04 expedition. I just bought it and the headlights were aiming too far down. A rather larger gap was noticeable between the headlight and the hood. The so called adjustment bolt did nothing. I removed the headlights and found 2 issues. On the adjustment bolt there is a washer. Make sure when you re-install the headlight the washer sets on top of the plastic slot and is visible when looking down behind the headlight. Without the washer being in the correct location it will not tighten the headlight in place.
Second I found the adjustment bolt adjusted nothing. It merely tightened the headlight in place. What I had to do was to loosen this bolt and physically move the headlight into place and the re-tighten the bolt. Hence the slot is the adjustment. Turning the bolt CW or CCW did not move the headlight.
I tried several things trying to figure why the lights would not move until I realized I could move the light with my hands and tightened them in place using the adjustment bolt.

This may not be your issue but I found the owners manual instructions to be useless.

Posted on Jan 02, 2009

Ad
mecanica03
  • 918 Answers

SOURCE: 1990 Lexus ls 400 transmission

yes, no problem

Posted on Apr 13, 2009

  • 29 Answers

SOURCE: front strut replacement 1990 lexus ls 400

u will need to remove tires and support car on jack stands under the hood u will find three nuts holding the strut up u can only pull strut off once u hav removed all other bolts from below car... go to auto zone.com and look up repair manuals they will be free after u sign up which is also free

Posted on Apr 21, 2010

  • 7 Answers

SOURCE: What does headlight leveling mean

Most of the luxury models and most newer vehicles have a bubble level that is on the back side of the headlamp that can be seen with the hood open and the may be an access cover that wil have to be opened to see it. There is an adjustment on the headlight to "level" the headlight for an optimum projection without blinding oncoming traffic. Here is the thing, you must make sure you vehicle is on a perfectly level surface before leveling you headlamps or everything you do will be a waste of time.

Posted on Nov 01, 2010

Testimonial: "Wow...thanks for the fast response.."

  • 64 Answers

SOURCE: I need to adjust the

it should be behind the headlight,turn both ways to determine which direction light is going

Posted on Nov 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Replace headlight bulb


  1. INSTALLATION GUIDE:
  2. BMW E38 99-01 HID TYPE 7 Series 1PC Halo Amber Projector Headlights
  3. Parts Identification:
  4. Projector Headlight
  5. Halo & L.E.D.
  6. Bottom of the Headlight:
  7. Ballast Bracket, Halo Wires(red/black)
  8. Turn Signal Adaptor
  9. TOOLS REQUIRE
  10. 10mm - 8mm socket
  11. Philip Screwdriver
  12. Crimper/Pliers
  13. For more information about how to install your vehicle, come visit our youtube page on
  14. http://www.youtube.com/spyderauto
  15. Remove the facotry headlight from the BMW. First remove the front panel cover below the headlight to access the bottom screw of the headlight housing. There is also two screws on the top of the housing.
  16. Once you have remove the headlight, turn the headlight around and remove the bracket that holds the Ballast. Then remove the ballast using a philip screwdriver.
  17. Unplug the wire from the ballast, and then remove the Xenon Plug from the housing. Put the Ballast aside.
  18. Carefully remove the D2S Xenon Bulb from the factory housing. Once you have remove the bulb, transfer the bulb to the Spyder headlights.
  19. Remove the bracket from the Spyder Headlight, and then install the ballast on the housing like the original. Once you have put the ballast on, put the bracket back on.
  20. Remove the Panel Cover bracket from the original headlight to the new Spyder Headlights as shown here.
  21. STEP:
  22. Install the Spyder turn signal socket if the orignal does not fit, unplug the factory plug from the harness and plug the new one on.
  23. Install the Spyder Headlight back on to the vehicle. Plug the Harness back on, the halo/L.E.D. Wires is connect to the Parking lights. These wires are optional to your vehicle, you do not have to wire them together.
  24. Factory Xenon Headlight
  25. Spyder Projector Headlight using Factory Xenon Lights
  26. STEP:
  27. PLS VOTE ME
BMW e46 HID Headlight Replace
replace-headlight-bulb-afy5cnsznmokzumyhdcbeseq-5-0.jpg

replace-headlight-bulb-afy5cnsznmokzumyhdcbeseq-5-2.jpg

Nov 23, 2012 | 2000 GMC Denali

2 Answers

How do I get to the front headlight to change it


Re: Replace headlight bulb

  1. INSTALLATION GUIDE:
  2. BMW E38 99-01 HID TYPE 7 Series 1PC Halo Amber Projector Headlights
  3. Parts Identification:
  4. Projector Headlight
  5. Halo & L.E.D.
  6. Bottom of the Headlight:
  7. Ballast Bracket, Halo Wires(red/black)
  8. Turn Signal Adaptor
  9. TOOLS REQUIRE
  10. 10mm - 8mm socket
  11. Philip Screwdriver
  12. Crimper/Pliers
  13. For more information about how to install your vehicle, come visit our youtube page on
  14. http://www.youtube.com/spyderauto
  15. Remove the facotry headlight from the BMW. First remove the front panel cover below the headlight to access the bottom screw of the headlight housing. There is also two screws on the top of the housing.
  16. Once you have remove the headlight, turn the headlight around and remove the bracket that holds the Ballast. Then remove the ballast using a philip screwdriver.
  17. Unplug the wire from the ballast, and then remove the Xenon Plug from the housing. Put the Ballast aside.
  18. Carefully remove the D2S Xenon Bulb from the factory housing. Once you have remove the bulb, transfer the bulb to the Spyder headlights.
  19. Remove the bracket from the Spyder Headlight, and then install the ballast on the housing like the original. Once you have put the ballast on, put the bracket back on.
  20. Remove the Panel Cover bracket from the original headlight to the new Spyder Headlights as shown here.
  21. STEP:
  22. Install the Spyder turn signal socket if the orignal does not fit, unplug the factory plug from the harness and plug the new one on.
  23. Install the Spyder Headlight back on to the vehicle. Plug the Harness back on, the halo/L.E.D. Wires is connect to the Parking lights. These wires are optional to your vehicle, you do not have to wire them together.
  24. Factory Xenon Headlight
  25. Spyder Projector Headlight using Factory Xenon Lights
  26. STEP:
BMW e46 HID Headlight Replace
get-front-headlight-change-afy5cnsznmokzumyhdcbeseq-5-0.jpg

get-front-headlight-change-afy5cnsznmokzumyhdcbeseq-5-2.jpg

Nov 22, 2012 | Cars & Trucks

2 Answers

Lt. headlight low beam wont work after replacing the bulb.


I assume it didn't work before you changed the bulb either. You'll have to check for voltage at the bulb socket when the low beam headlights are turned on. If there is none you'll have to trace the wire back to where it splits from the right low beam headlight. If there is voltage there you have a problem with the new bulb.

Apr 10, 2011 | 1991 Lexus LS 400

1 Answer

1990 Lexus ls 400 headlights work but car won't start or make any noise


Make sure the battery is fully charged. Try jumping it or using a jumper box.

Mar 11, 2011 | 1990 Lexus LS 400

1 Answer

How to replace the headlight?


    1. Openthe hood of your Lexus and remove the power connector from the back of theheadlight. Press down on the release tab on the top of the connector and pullit off from the headlight. 2. Rotatethe headlight collar counterclockwise and pull it out of the housing assembly. 3. Inserta new headlight into the housing and rotate the headlight clockwise to secureit to the housing. 4. Plugthe power connector back into the headlight.

    Mar 05, 2011 | 2006 Lexus Rx 330

    1 Answer

    How to change bulbs for back brake lights on 1990 lexus Ls 400


    open the trunk and take down the liner inside the trunk and there are some 10 or 12 mm bolts there to take the tail light assembly off the car and you can change the bulbs from there.

    Jul 16, 2010 | 1990 Lexus LS 400

    1 Answer

    How do you replace the headlight on a 97 lexus es300. Thank you


    Obviously the furst thing you need to make sure you have are the replacement lights

    Step 1 Open the hood and unplug the HID power connector from the back of the headlight assembly

    Step 2 Pull the protective rubber boot off the headlight housing.

    Step 3 Squeeze the tabs on the wire clip that holds the headlight in place.

    Step 4 Pull the headlight out of the back of the headlight housing assembly.

    Step 5 Insert a new headlight.

    Step 6 Secure the headlight with the factory wire clip.

    Step 7 Replace the rubber boot.

    Step 8 Plug the HID electrical connector back into the headlight.

    Mar 29, 2010 | 1997 Lexus ES 300

    2 Answers

    How do you change the headlight bulb on a 1996 lexus ls 400


    I can't tell you exactly how to do it on a lexus but generally bulbs are changed from the rear of the assembly inside the engine compartment. you may have to remove the battery if it is on that side. do not touch the bulb with your fingers as that will shorten it's lifespan.

    Apr 08, 2009 | 1990 Lexus LS 400

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    241 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Lexus Experts

    Marvin
    Marvin

    Level 3 Expert

    85108 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22484 Answers

    Jonah Oneal

    Level 3 Expert

    14092 Answers

    Are you a Lexus Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...