I need the specs for the main bearing and connecting rods on a 2000 Nissan Xterra 3.3 v6

SOURCE: main and rod bearing torque specs

do you have a Haynes Manual or Chilton? if not check your local library, they may have one, the specs are in there

mx5turbo92

• 545 Answers
• Posted on Jun 04, 2009

SOURCE: i'm looking for the 2000 isuzu rodeo 3.2L v6 connecting rod bearings torque specs.

1. Check the connecting rod alignment If either the bend or the twist exceeds the specified limit,the connecting rod must be replaced. Bend per 100 mm (3.937 inch) Limit: 0.15 (0.0059) Twist per 100 mm (3.937 inch) Limit: 0.20 (0.0078)

2. Measure the connecting rod thrust clearance. Use a feeler gauge to measure the thrust clearance at the large end of the connecting rod If the clearance exceeds the specified limit, the connecting rod must be replaced. Standard: 0.16 mm - 0.35 mm (0.0063 inch - 0.0138 inch) Limit: 0.40 mm (0.0157 inch)

3. Measure the oil clearance between the connecting rod and the crankshaft.

1. Remove the connecting rod cap nuts and the rod caps (12). Arrange the removed rod caps in the cylinder number order.
2. Clean the rod bearings and the crankshaft pins.
1. Carefully check the rod bearings. If even one bearing is found to be damaged or badly worn, the entire bearing assembly must be replaced as a set. Reinstall the bearings in their original positions. Apply plastigage to the crank pin.
2. Reinstall the rod caps (12) to their original positions. Tighten the rod cap nuts. Torque: 54 Nm (40 ft. lbs.) Note: Do not allow the crankshaft to rotate.
3. Remove the rod caps.
1. Measure the width of the plastigage and determine the oil clearance. If the oil clearance exceeds the limit, replace the rod bearing as a set. Standard: 0.019 mm - 0.043 mm (0.0007 inch - 0.0017 inch) Limit: 0.08 mm (0.003 inch)
2. Clean the plastigage from the bearings and the crankshaft pins.

SOURCE: need torque specs for 1.3 liter motor,connecting

MAIN BEARING TORQUE IS 36 -41 FT LBS. ROD BEARING TORQUE IS 24 -26 FT LBS

Steve Allison

• 5569 Answers
• Posted on Feb 20, 2010

SOURCE: need torque specs 1988 Chevy silverado for main bearings and rod

Those values and most everything else you need for DIY work are contained in the Haynes manual for your vehicle. We have one with each of our vehicles and not only give you the info needed to do repairs yourself but also get an idea of how much work a specific repair should (or shouldn't) cost.
'88 Chevy pickup manual
You can also buy these from auto parts stores for a few dollars less and sometimes on eBay for even less.

SOURCE: Need torque specs for 2000 Ford taurus 3.0 flex

main bearing caps 56-62 foot pounds connecting rod caps 1st pass 17 foot pounds 2nd pass 32 foot pounds......................HAVE FUN