I have 01 nissan maxima and it has p132 code and cutoff but will crank back what is the problem

SOURCE: 96 Nissan Maxima. Has new starter. Wouldn't

Did you have the new starter tested befor you installed it? Was their a lot of corosion on the battery cables? The cables might be corroded as well cousing too much resistance for the starter to crank.

SOURCE: 95 nissan maxima wont start

I had a 94 which i fixed this same type of problem by putting in a new distributor

honeymokey

• 3113 Answers
• Posted on May 15, 2010

SOURCE: code p132

P0132 Oxygen Sensor Circuit High Voltage (Bank 1 Sensor 1) -

SOURCE: reset code for 2006 nissan maxima radio...

just changed battery,,all good,,radio is out,,tried fuses ,, what can i do to get the radio back on...

SOURCE: How do i fix p1130 AND P 1440 code on my 2000

P1130 Swirl Control Valve Circuit Malfunction - With Automatic Transmission Possible Causes

• Check for air leaks in the Air Induction system (e.g., in the intake manifold)
• Check for leaks or looseness in hoses and tubes between the intake manifold, vacuum tank and swirl control valve actuator
• Check for leaks or looseness in the hoses between the air cleaner assembly and the swirl control valve vacuum check valve
• Crankshaft position sensor (REF) signal problem
• MAF sensor has failed (it may be dirty or contaminated)
• One-way check valve has failed
• Swirl control valve actuator has failed (it may be damaged or sticking)
• Swirl control valve control connector is damaged (check pins for damage)
• Swirl control valve circuit is open, shorted to ground or shorted to voltage
• Swirl control valve has failed
• PCM has failed
• Throttle position sensor has failed
• Vacuum tank has failed