The location of the map sensor on a 1996 chrysler convertible sebring jx 2.4 engine

In 1996, Chrysler made Sebring Convertibles with two engine types:
Select the engine of your 1996 Chrysler Sebring Convertible:

Available engines
4 Cylinders X 2.4L SFI DOHC
6 Cylinders H 2.5L MFI

The VIN 8th digit will be "X" or "H" as in the table above.

On 1997 Chrysler Sebring 2.5L MFI 6cyl...
- the PCM is located in the left side of the engine compartment, beside the Power Distribution Center (PDC).



Fig. 1: Location of the PCM on the Cirrus, Stratus, Sebring convertible and Breeze models



Fig. 2: Location of the PCM on the Sebring coupe and Avenger models

- the Crankshaft Position Sensor is located: under hood, driver side, upper engine area, mounted on end of engine block



Fig. 4: Location of the crankshaft position sensor on 2.5L engines

Hope helps; remember to rating this answer and leave some testimonial comments.

You may have a bad map sensor or idle control sensor. You may need to adjust the idle itself.

Welcome to FixYa.com
Regards, Lee Davidian

check for loose connections on relays

Fig. Heated Oxygen (HO2S) location (sensor 1)-2.4L engine



Fig. Heated Oxygen (HO2S) location (sensor 2)-2.4L engine



Fig. Heated Oxygen (HO2S) location (bank 1, sensor 2) (bank 2, sensor 2)-2.7L engine



Fig. Heated Oxygen (HO2S) location (bank 2, sensor 1)-2.7L engine

I hope help you with this (rated this help). Good luck.

Depending on the tightness of the socket fit and the engine, carefully pull the spark plug out of the bore



Hope this helps some...best that I can find!

Go to link below for instructional video's on brake rotor replacement.

http://video.google.com/videosearch?q=how+to+replace+brake+rotors&www_google_domain=www.google.com&hl=en&emb=0&aq=0&oq=how+to+replace+brake+r#

you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.