I need to know where I would find the bushing for the subframe of my Pacific Chysler 2004 2 wd

And the question is ?

At dealer.

you can look at them and compare them to see if they are the same size and thickness. if not get new ones.

lots of things can make it "pop". check the hub bearings, the stabilizer links, the tie rod ends, the balljoints, the struts and strut mounts, the engine cradle bushings, the control arm bushings ,and the engine mounts. GOOD LUCK!

The suspension on these vehicles fall apart. I would inspect the lower control arm bushing first. Look for cracks in rubber or for control arm hitting subframe at rear bushing. If Okay inspect Front strut and mount. Most likely this is the problem. Also inspect the stabilizer link pin for play

I just loosen the bolts of the subframe and use a bar to pull it down abit , while my lad changes the bush, or you could pull it down a bit and block it with a bit of wood, so you can change the bush safely.

it really isn too badd what you need to do is loosen all four then you just take ou the bolts in the front leave the rear in loose but in then the front will come down low enogh to get the upper pieces out then reassemble the front leaving bolt loose then do the same to the rear then tighten all the bolts back up

It is highly unlikely that the bushings will fail. They do tend to crack alittle, but the bolts will still hold the subframe on. Now if they are rusted out, this is a possibility. You do have 4 bushings holding the subframe on also. 2 at the front, and 2 at the back.

Its called Control Arm Bushing ..Please click on this link..
http://www.autozone.com/N,14600793//shopping/partTypeResultSet.htm