SOURCE: 2002 VW Jetta Overheating
Stop driving the car asap, have it checked and fixed, otherwise you could be facing very expensive repair in the ery near future.
SOURCE: 2004 VW Jetta engine compartment fuze box location
one is located over the battery, the other is located in the side of the dash.
First panel:
If you pop your hood the battery will be on your right sid in the front of the engine bay. There is a small rectangular piece on top of the battery with a lot of heavy guage red wires going to it. That is the engine bay fuse box.
Second panel:
if you open your driver side car door it's under neath a panel located inbetween the door and the dash board.
SOURCE: On-line parts diagram AC/Heater
Blend doors are in the heater and A/C box, typically not a job for non professional, very very delicate
SOURCE: 96 LINCOLN TOWNCAR STUCK ON HEAT ONLY !
The heater and a/c blend door actuator motor is located behind the center of the dash just below the windshield. The steering column must be detached and lowered and the dash must be removed to access the blend door motor.
SOURCE: 2006 vw jetta No power on drivers door.
I have the same Problem. I Simply cut into the middle of the boot between the door and body The broken wire was right there, I pulled each end out and held the wire there with a pair needle nose pliers, stripped the end with a knife and attach a mulyi-strand jumper between both ends with electrial wire twists. Leave 2" approx. then slip the boot back over them. Use # 14 Wire. A Quick reasonable fix. If brakes again repeat again. The new Haness will have the same Problem down the road.
John
Testimonial: "I had the problem fixed at the dealer. It was the harness They made the harness longer & it was free.. "
In all modern cars there is a tiny DC electric motor driven gear drive that moves a plastic door that blends heated and cooled air from the AC and the heater core, this is called (interestedly enough) the air temperature control blend door actuator. The motor that moves this door fails because the door starts sticking from warping, most common complaint is no heat but it can be no AC as well. To replace these parts (blend door and blend door actuator) you must remove the entire dash from the car. Always have this problem confirmed by a dealer or qualified repair shop as it is a very expensive repair.
308 views
Usually answered in minutes!
×