SOURCE: low beams
hello i no you said you checked your fuse box go under your hood drivers side near your strut tower their problay is a second fuse box its black some times fuses is on the cover you have to unlock the side of cover lift off on inside of cover will list what is what sometimes left and right headlamps are seperate fuses goodluck
SOURCE: 05 Jeep Wrangler High Beams Work, Low Beams dont
There are no relays for the headlights. Your problem could be from the headlight switch. You would have to check and see if you have power coming out of the switch on the low beam side. Check with a test light.
SOURCE: High beams work but low beams do not. Fuses seem to be good
Hi
I would start with the dimmer switch if you know the lights are good dimmer switches do this you will lose your high beam or you will lose your low beam when they go bad.
SOURCE: low beam not working but high beam is-Pontiac Vibe 2005
I have heard it could be the Daylight Running Light module located under the dash above the brake pedal. The module controls both the daytime running lights and the low beam lights. The high beams are independent of this module.
I have the same problem. I am trying to buy a new module.
SOURCE: Low beam head lights not
if the fuses are good then you need to check for power and ground at the headlight plug that attaches to the headlight bulb if you have a good power and ground there and the connections are good then the bulbs are both no good.or if you can tell the bulbs are burnt out by looking at them then you don`t have to check powers and grounds.you also can directly feed power and ground to the bulb and check both the terminals for high beam and low beam as you cannot tell which is which by looking at the terminals
115 views
Usually answered in minutes!
×