How do I remove the starter on my 1993 Acura Legend?

SOURCE: removal of the driver seat of my 1988 acura legend

I'm not certain of the layout of the bolts on your particular model, but there should be 4 bolts, one at each end of the seat tracks (the things the seat slides back and forth on), attaching the tracks to the floor. You may need to slide the seat back to access the front bolts, and forward again to get the back ones. Tilt the seat back right forward to allow you to get the seat out the door. If the seat has electric controls there will be some plugs to disconnect under it. If there are any yellow coloured plugs, DO NOT disconnect them without disconnecting the negative terminal off the battery and waiting for 5 minutes. The yellow plug is an airbag system plug, and if the battery is not disconnected the airbags could potentially deploy. Make sure the battery remains disconnected for the entire time that the yellow plug is disconnected, and reconnect the battery AFTER the yellow plug. If there isn't a yellow plug, don't worry.

Hope this helps.

SOURCE: acura legend

I will require more information on this issue. Like how do you mean it won't move. In forward as well as reverse, does it try to move, etc.
Bill

SOURCE: 1993 Acura Legend Overheating.

This could happen if your fan is indeed weak.  To test disconnect the thermostat of the radiator by removing the terminals near the radiator hose towards the engine.  You should see the fan run at its highest speed, then you can check if your fan has weakened.

SOURCE: Can you disable car alarm in 1991 Acura Legend by

If it's a cheap aftermarket alarm, check for a red wire coming off the hot side of your battery with an inline fuse. If it's not, try to locate the alarm "computer" under the driver's side dash or nearby your fuse panel. You'll find a black box with a wiring diagram glued to the side, normally strapped to a wiring harness or other fixed element. If this is the type of alarm you have, you'll need to trace each wire coming from the alarm computer and unclip each fastener that's clipped to your vehicle's factory wiring. The trouble with these types of alarms is that they can get power from a number of sources (stereo, interior lights, etc.). Good luck with this one!

SOURCE: how to remove starter from 1991 acura legend

Follow the battery wire (disconnected) to the starter and remove the nut and solenoid wire. There should be two bolts to the bellhousing (a old term for the transmission to engine piece).