Can you use a used pass key 3 from another van
SOURCE: Thermostat in a 2003 chevy venture van
the bottom boult is hard but can be done need to use a 10 or 12 stubby wrench and take a pry bar and lighty pry heat shild away to get bottom bolt dont need to take it out all the way just loosen and slide down
SOURCE: blower fan
it sounds to me like your blower moter resister or your blower moter switch are going bad both are right under the hood next to the blower moter one has 2 witers on it the other has 4 it usuley on the pass side right near the window
SOURCE: rear brakes scrubbing on 1998 chevy venture van
Removal Procedure
Tools RequiredJ 38400
Caution: Keep fingers away from rear brake shoe springs to prevent fingers from
being pinched between spring and shoe web or spring and backing plate.
Installation Procedure
Notice: Do not over stretch the adjuster spring. Damage can occur
if the spring is over stretched.
Important: Ensure that the adjuster (2) engages the brake shoes (4 and 5), the
park brake actuator (3), and the adjuster actuator (1) properly.
Notice: Do not over stretch the adjuster spring. Damage can occur
if the spring is over stretched.
SOURCE: Thermostat in a 2003 chevy venture van
no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.
SOURCE: Radio, Key auto door lock/opener, interior lights not working.
Most likely is a fuse. There is a fuse box at the end of the right side of the dash. Open front passenger door and there is a cover that says fuses on the end of dash. There is also a fuse box located under the hood at the right front of engine compartment. It should have a cover with a round knob in the middle of it .Unscrew the knob to remove cover.
60 views
Usually answered in minutes!
×