How do I replace the whole headlight assembly?

There should be three screws holding it in from behind. They will be three long post looking type of stand offs. Remove those and the whole assemble will come out with a pop.

The starter relay is mounted on the starter itself. To see if the relay itself is working, check for voltage on the small wire on the relay while someone is turning the key to the "Start" position. If you have voltage there but the starter doesn't work, then replace the entire starter and relay assembly.

Check the choke buterfly in carby is closed when cold (the butterfly at the top of the carby) if not find out why it may be cable problem or just need a little spray with WD40 where the rod the butterfly is mounted to goes through the carby.

i had to jack motor up a little bit but becareful not too much u can brake wires n other things

the only way to effectively repair the lens is to replace the whole assembly

i just buy this car all the outher lites work the instr.panel is dark i dont know how to trun it up

There r ways around that if u follow the brake line u could cut the broken one right before the gas tank then flare it n connect a new line n run it on the side of the gas tank with wire ties . Also u can put a compression fitting on the line u cut after the gas tank that's Wat I did two years ago n they r still working fine .if u can get the flare kit do it that way cuz I belive they can fail u for the compression fitting

Blower Motor Switch Resistor Assembly REMOVAL & INSTALLATION Fig. 1: Remove the resistor assembly by gently popping it out of the evaporator housing using a screwdriver

1. Disconnect the negative battery cable.
2. Remove the push pins and remove the upper footwell panel from under the passenger side of the instrument panel.
3. Unplug the connector from the blower motor resistor assembly.
4. Insert a screwdriver approximately 0.2 inch (5mm) under the edge of the resistor assembly to disengage it from the evaporator housing.
5. Remove the resistor assembly. To install:
   
6. Position the resistor assembly into the housing and snap it into place.
7. Attach the resistor connector.
8. Install the upper footwell panel.
9. Connect the negative battery cable.

Step 1
Remove your Contour's front grille. You can do this by raising the hood and removing two screws that are located on top of the grille.

Step 2 Remove the headlight assembly. The headlight assembly is held into the front of your Contour by three screws. Two screws will be located on top of the assembly, and one on the bottom.

Step 3 Replace the headlight assembly, if necessary. If you are only changing individual bulbs, make sure you replace the correct bulbs. Each assembly holds three light bulbs, including the bright, dim and turn signal bulbs.

Step4 Replace the headlight assembly and reattach the three screws to hold it in place.

Step5 Replace the front grille of your Contour and the two screws that hold it onto the front of the car.

• It is usually a good idea to replace bulbs together (in pairs). This will allow the bulbs to wear at the same rate.
• If you choose to replace only the individual light bulbs, do not touch the new light bulbs. The contact of your skin on the bulbs will cause the light bulbs to burn out much sooner.

Let me know if you have any further questions.


Benjamin

If it had any head work done such as valve grinding. there could be a valve a tad shorter and may
result in a noise until the engine warms up. That is what i hear the problem is with mine. There
was no noise before i had the head work done.