Why is the driver window not working?

DR/LCK fuse 20 amp - location - under hood fuse box , check this first . Just the driver's power window doesn't work or all windows don't work ? Power locks don't work with key fob or from driver door master switch ?

! fuse for all window are other working look driver window motor or driver switch

you might want to check your ground wires and make sure there all tight

at all stations?
all fuses, in both boxes. (did you read the operators guide to find them,
some cars have a circuit break (thermal) for windows,
and is located in the fuse box.
all this info is at alldata.com
ill look. ill respond , as you are a pro DIY person, can read schematics. if not , its just a guessing game.
IT IS a FUSE, not a breaker. but each motor in door has CB.
UNDER HOOD 40am Fuse #13
then fuse 23 underdash and fuse 8 same.
then the relay.same place.
and the relay is controlled by, master station (drivers)
the driver location doesnt need the relay to work.
the relay feeds power to all other window controls
so the master station is unique.
log in to alldata.com and see the pages on power windows.
here are some tid bits.
battery pull warning

Resetting the power window control unit is required after performing the following procedures: Disconnecting the battery, Removing the No. 6 (7.5 A) and/or the No. 23 (20 A) fuses from the under-dash fuse/relay box or disconnecting the driver's door wire harness.
and
window relearn/reset.
Control Unit Reset

1. Turn the ignition switch ON (II).
2. Move the driver's window all the way down by holding the driver's switch firmly down; when the window reaches the bottom, hold the driver's window switch firmly down for 2 seconds.
3. Move the driver's window all the way up by holding the driver's switch firmly up; when the window reaches the top, hold the driver's window switch firmly up for 2 seconds.
4. If the window does not work in AUTO, turn the ignition switch OFF and repeat the procedure.
5. Check the window and power door lock operations

Fuses are located nex to your feet near the pedals or next to the passengers feet.

CHECK FUSES FOR POWER WINDOW,CHECK FUSE FOR POWER MIRROR AND CHECK FUSE FOR POWER DOOR LOCK.IF FUSE OKAY DOOR CONTROL MODULE FAULTY ITSELF.

the fuses for the windows will be in fuse box, it sounds like possible water intrusion,the fuses should all be marked, if they are all good,you may have to remove the door panel to check for any damage at door switches

not sure on this make but many vehicles have a lock out switch (safety feature) that deactivate all power windows except for the driver window. Usually on the driver door or close by

should be a fuse in engine compartment drivers side black box and there will be fuses for each sep. window.chech the fuse-under box cover the fuses are labled.if fuse good may have bad switch-check <remove switch from panel after removing panel.check with key on for power at switch if power is good press switch chech power on motor by removing wire connector and test with light/meter at connector.if power good motor bad>hint motors are interchangable so you can use rear drivers motor for example before you buy anouther motor.i have 4 good ones if you need :-> [email protected]

If it's all your windows not working from the driver's seat, then it's your window switch on the driver's door or it may be a fuse(I doubt it's a fuse). If it's just one window, then it's the motor inside the door of that one window.