Any help/diagrams would be wonderful please.
You need to post the engine size, but if it's the 2.5 engine, you need to loosen the tensioner, remove belt, pull the supporting bolts, and the hoses, and if the new pump does not come with a pulley, (typically they don't) then you will need to get a pulley remover and installation tool). DO NOT HAMMER THE PULLEY BACK ON OR YOU WILL DESTROY THE NEW PUMP!
Installation is in reverse, but when you tighten the tensioner, do not overtighten the belt 1/2 inch flex between the pulleys is good so long as the belt doesn't squeal or make any noise. Tighten the lock nut or bolt, and the other bolts, top the recommended power steering fluid off, cycle the steering wheel full right and full left 30 times to ensure all the air is purged from the system, shut off engine and top off fluid to the recommended level. DO NOT OVERFILL!
SOURCE: Replace 2005 Nissan altima stereo receiver
Try radio shack, or stereo sales/installation place for ready to go plug adapter. For a few bucks, it saves headaches, and butchering the wiring in case you want to re-install old one later when trading in or selling the car.
SOURCE: need factory wiring diagram please.
Many times the local library will have a technical section with wiring diagrams in them. Some you can even get online. Good Luck!
SOURCE: how do i put new spark plugs in a nissan 1998
I can't tell if you need to know how to replace the spark plugs or just need the wiring diagram, so i'm giving you a link to a "how to" video.
http://www.wonderhowto.com/how-to/video/how-to-replace-spark-plugs-203687/
Since you didn't memorize the wiring order, here is a diagram...
SOURCE: 2002 Nissan Altima Exterior Door Handle
I seriously doubt that supergluing or even epoxying a handle back will hold at all, or hold for more then few days.
I would only suggest doing the replacement yourself if you familiar with this type of work, or has the aptitude to figure out how to do it, and have the right tools because it is NOT trivial and a number of things can be done wrong, broken or scratched.
The handle itself cannot be replaced. The outside door handle assembly (which includes the handle, the bezel with all associated springs, plastic and metal hardware) has to be replaced. Besides junkyards, which is a long shot for number of reasons, the only place where the handle assembly can be bought is the dealer. And these handle assemblies are not cheap ether. The driver side handle on my 2002 Altima broke first. I paid $60.23+tax, and they had to order it. BEFORE anyone goes to the dealer I suggest to call first, and ask them if they have it in stock. Since door handles are sold painted they will ask you for your car's VIN number so that they match the paint color.
After you pick it up, the replacement will take about an hour (if you know what you doing). The inside door panel has to be removed, it is held in place by the inside door handle and the panel is attached by a number of clips, the handle assembly is attached to the door by three bolts, to remove which you will need a socket with extension. You will also need a good flashlight so you see what you are doing.
If you are familiar how to do this type of work and plan to keep the car for a while I strongly suggest buying a factory service manual on a CD (I bought mine on eBay for under $10). It is worth its price 1000s of times over, and makes almost ALL repair work SOOO much easier.
167 views
Usually answered in minutes!
×