Thermastate and high heat

open glove box remove users guide
turn to end ,index see words, FUSE an go there.
bingo

The speedometer on a 2004 Grand Charokee gets its signal via the PCI data bus from the ABS control module. Both rear wheel speed sensors are used for the speed signal.

I owned a 93 GC 4x4 and I did replace my front axles with CV joint axles. The new axles came with CV joints, with a rubber boot and all so yes you can.

What about the fuel, was it drained and the system flushed. Gas turns to goop after this long and will barely burn.

There's a small motor inside that is probably shot. Of course the switches have a tendency to stop working if treated harshly. If you hear the motor run but no movement, its an armature broken or even a missing pin. You'll want to check armature anyway since if stuck it'll burn a motor easily.

Check your spark plug, wires, distributor cap and finger. If you spark plugs older than 15000ml, replace them. To check your spark plug wires, use a tester (U can buy at any auto store) you hold direct on the wire and a small sparkling will show you if the wire works or not. You can check the wires also with this: use a single spark plug (don't remove one out your engine!), remove the wire from first SP, connect it with the single SP, hold it to ground, let someone start your engine...you need to see regular sparks.. do this step by step with all 6 wires. If all wires are fine, check the SP's, If you miss on one wire, replace the wire, if you miss on more than one, chekc the distributor cap and finger. If this items are older than 20000ml or 5 years, replace them.

Disconnect and Isolate Negative Barrety cable. Remove screw in bottom of steering column shroud cover. ( bottom side of steering column between wiper switch and turn signal switch) Unsnap shroud halves and remove from column. Disconnect wireing harness connector from multi function switch. Remove 2 screws securing switch to mounting housing. Install in reverse order.

The Blend door in the HVAC box. Unfortunatly this is the main cause of this type of problem u have to remove the dash and replace the blend door and the acuator.

their is a panel in the interior qtr panel and may have 2 screws inside at latch take the screws out and check inside of qtr and lightly hit the outside of lamp while trying to pull it out.

its on the passenger side firewall under the hood you cant miss it its the only thing with a otor there...