Are the spark plugs located under the valve cover or can u get to them from the top

The spark plugs are located under the four spark plug wires that go through the middle of the valve cover on top of the engine. With a twisting motion, remove the plug wires from the spark plugs. Then using a 5/8 inch spark plug socket and inch extension on a 3/8 inch ratchet, remove the spark plugs. Gap the new plugs to the correct gap (located on the label on the underside of the hood), and in stall into the holes in the valve cover using only your hand to get them started, then tightening with the ratchet. Then reinstall the wires back to their original locations, and you are finished.....

under the intake plentum remove it then the coil packs and have fun with number six it a littloe tight back towards the fire wall.

Sparkplugs are located on top, remove the top cover over the valve cover and you will see coils going into holes on the top of the valve cover, remove the coils unplug connector and your plugs are located under each coil, good luck.

If your sportage has the 4 cylinder engine, there is a plastic cover over the engine that is held down by 4 bolts, one at each corner. Remove the bolts with a 10mm socket and lift he cover off and lay it aside. You will see the spark plug wires and the 4 holes where the spark plugs are. The spark plugs are about 4 inches down into the holes. Be careful removing the spark plug wires, they will be tight, and you will have to rotate them back and forth while pulling up to get them loose.

O-ring seal for spark plug are leaking. Located under valve cover.
To replace them,
1.unplug spark plug wire from spark plug.
2.remove valve on top of engine, by loosing the 5(10mm) bolts and disconnecting air hose.
you might have to use a pry bar to pry valve cover off.
3. flip cover upside down and you'll see that there's one o-ring per spark plug hole. remove them and install new one. You might want to replace valve cover gasket too.

remove the plastic cover that bolts to the top of the valve cover. The plugs will be under there.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

There is a tunnel intake tube,remove it,but there is a black plastic vacuum reservoir on the back connected to it,remove it first,it is not easy to do,after these are out of the way,the black plastic cover that goes down the middle of the valve cover has the coils,two of them,and two wires,and four spark plugs under it.If this was at all helpful,please rate,and thank you.

there is no wires this truck has over head coils for each cylinder. they are bolted to the top of the valve cover and go down through the valve cover to the spark plug.

under the spark plug coils on top of valve covers. You take of coil off then you can see plugs inside of valve cover.

**if the Eng 4 cylinder they are located under the coil bord which is on the top of the Eng tide with 4 bolt 13mm
*** if 6 cylinder they located under neath the valve cover or u can follow the spark plugs wire