SOURCE: installing new brake pads on 2000 hyundai Accent GL
REMOVAL
1.
Remove the lower bolt and lift the caliper assembly up and secure it with a wire or some other retaining method.
2.
Remove the pads.
CAUTION: Do not depress the brake pedal while disassembling the pads
INSPECTION
1.
Check the pads for wear or oil contamination and replace, if necessary.
•
The pads for the right and left wheels should be replaced at the same time. Never "drop" or intermix brake pad sets.
•
All four pads must be replaced as a complete set.
•
When replacing the brake pad, check for deformation. When replacing the guide spring, use a new one or the used one after cleaning away foreign material.
2.
Check the pad for damage or deformation.
Brake pad thickness:
Standard value: 9 mm (0.354 in.)
Service limited value: 2 mm (0.0787 in.)
INSTALLATION
1.
Install the pad clips.
2.
Install the pads onto each pad clip.
3.
Insert the piston in the cylinder using the Special Tool (09581-11000).
4.
Install the new pads. The shims are attached to each pad as illustrated
Be careful so that the disc or pad isn't contaminated by grease.
5.
Install the bolt and tighten to the specified value.
Tightening torque
Guide rod bolt: 22~32 Nm(220~320 kgf·cm, 16~24 lb·ft)
SOURCE: Hyundai Accent 2000 shows overdrive OFF( OD OFF)
There is a button on the shifter that turns the OD off and on.
SOURCE: 2000 windstar anti theft system
un hook battery and wait about an hour or so and use factory key if wont fix dealer has to reset.
SOURCE: Hello accent 2004 with anti theft system battery flat anti theft
Have you verified this system is running the battery down? The system you describe is called the Remote Keyless Entry System (Electronic Time/Alarm & Control System - ETACS Module). It cannot be 'disconnected' without disabling other systems (intermittent wipers, Chime bell, Door Warning, Dimming Off Room Lamp, Seat Belt indicator, remote power door lock/unlock system, etc.)
SOURCE: Replacing bulb (Headlight) in 2000 accent GL
once you pop the hood, there should be a cover behind the light housing that you twist to open the backing.. inside the housing will be a spring lever that secures the bulb down... unhook the spring and disconnect the harness connecting to the bulb...
419 views
Usually answered in minutes!
×