Question about Cars & Trucks

1 Answer

Keeps throwing up trouble codes p1506,p1151,p0302,p0171

It doesn't run rough all the time but seems to start usually after it's warmed up I've changed the plugs ,wires,coil pack, crankshaft sensor

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 10,875 Answers

Definition of Diagnostic Trouble Code P1506 Audi: Closed Throttle Position Switch Does Not Open/Short to Ground BMW: Idle-Speed Control Valve Opening Solenoid Control Circuit Signal High Ford: Idle Air Control Overspeed Error (see P0507) Jaguar: Idle Air Control System RPM Lower Than Expected - B Bank Kia: IAC Valve Opening Coil Voltage High Lincoln: Idle Air Control Overspeed Error (see P0507) Mazda: Idle Air Control Overspeed Error Mercury: Idle Air Control Overspeed Error (see P0507) Porsche: Throttle Jacking Unit Lower Mechanical Stop, Signal Implausible Volkswagen: Closed Throttle Position Switch Does Not Open/Short to Ground Volvo: IAC Valve Opening Signal
------------------------
Definition of Diagnostic Trouble Code P1151 Audi: Bank1, Long Term Fuel Trim, Range 1 Leanness Lower Limit Exceeded BMW: Oxygen Sensor Heater Circuit Signal Intermittent (Bank 2 Sensor 1) Ford: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Jaguar: Lack of H02S-21 switch, sensor indicates lean Land Rover: Lambda control limit bank 2.Implausible signal/condition Lincoln: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Mazda: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Mercury: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Subaru: HO2S-12 Heater Circuit High Input Toyota: Coolant Path Clog Up for Coolant Heat Storage System Volkswagen: Bank1, Long Term Fuel Trim, Range 1 Leanness Lower Limit Exceeded
------------
Definition of Diagnostic Trouble Code P0302 Category: Powertrain Definition: Cylinder 2 Misfire DetectedNote: This definition of P0302 is applied to all manufacturers
--------------------------
Definition of Diagnostic Trouble Code P0171 Category: Powertrain Definition: System Too Lean Bank 1Note: This definition of P0171 is applied to all manufacturers

Posted on Jun 17, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevy Silverado error p1151


P1151 Lack of Upstream Heated Oxygen Sensor Switch - Sensor Indicates Lean - Bank No. 2


p1131 p1151 p0171 p0174 p1131 p1151 p0171 p0174
All of these p1131 p1151 p0171 p0174 codes indicate a problem with a lean condition. This engine is known for vacuum leaks, so before you start throwing oxygen sensors at the problem, it pays to perform some diagnostics.
Start by cleaning the MAF sensor. Spray the sensor with CRC MAF sensor cleaner. Next, check the plastic vacuum lines, especially where they meet with rubber boots. If they are cracked or the rubber is swollen, replace the line. Then check the rubber elbow that holds the PCV valve. That elbow is a know failure point. In fact, the entire PCV tubing is a trouble spot on these engines. (thanks Ford).
After you've checked for vacuum leaks, check the operation of the oxygen sensors. The easiest way to do that is to disconnect the sensor from the harness. Connect one lead of your digital voltmeter to the black wire on the sensor and the other lead to battery negative. Then start the engine and add fuel (either propane, starting fluid, or carb cleaner) into the throttle body to force the mixture to rich. You should see a corresponding increase in voltage as you add fuel (from 0 volts to slightly less than 1 volt). Start and stop the fuel enrichment and watch the meter to see if the volts drop as you stop adding fuel. If you see no change, the sensor is dead. Replace it.
You can also use the fuel enrichment procedure to locate intake gasket leaks.
P1131 Lack of Upstream Heated Oxygen Sensor Switch - Sensor Indicates Lean - Bank No. 1
P1151P1151 Lack of Upstream Heated Oxygen Sensor Switch - Sensor Indicates Lean - Bank No. 2
P0174 system lean bank 2
P0171 system lean bank 1


This is the only info that didn't come back directly to FORD (yet still mentions it) instead of GM. Not to sure you got the correct code.

Jul 08, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

P1151 code


When you have both codes at the same time, it indicates that both bank 1 & 2 O2 sensors are reporting lean condition. If only one code appeared it is usually a bad sensor, but with both codes, it is probable that it really is running way to lean. This is usually caused by a vacuum leak. Make sure you intake hose from MAF sensor (air filter box) to intake is secured and has no leaks, then move on to looking for, vacuum hoses leaking, intake gaskets leaking etc...

Mar 19, 2014 | 1999 Ford Ranger SuperCab

2 Answers

2000 Lincoln Navigator - few days ago started idling very rough when truck is at a stop or in park. Service Engine Light came right around time I noticed that it was idling rough when stopped. Following...


P1131 Lack of HO2S-11 Switch ,Sensor Lean
P1151-Lack of HO2S-21 Switch ,Sensor Lean
PO171- System to Lean (Bank 1)
PO174-Systen to Lean (Bank 2)

Fuel Filter -Plugged
Low Fuel Pressure
Evap System -Leaks
Leaks - in ducting,air filter to throttle
PCV -Leaks
Exhaust System -Leaks
O2 Sensors-worn out

Apr 06, 2011 | 2003 Lincoln Navigator

2 Answers

How do i fix emission codes p1131 p1151 p0171


TSB
05-22-6
ISSUE:
Some 2001-2003 F-150, 2004 F-150 Heritage and 2001-2003 E-150/250 vehicles equipped with a 4.2L engine may exhibit the malfunction indicator lamp (MIL) on with diagnostic trouble codes (DTCs) P1131 and/or P1151 (system too lean bank 1 or 2). This condition may be due to leaking isolator bolts/port gaskets in the upper-to-lower intake manifold mounting area. This condition is sometimes intermittent and may not be apparent on a warmed-up engine.


SERVICE PROCEDURE

Perform a self test. If DTC P1131 and/or P1151 are the only codes stored in the powertrain control module (PCM) proceed to Step 2. If any additional DTCs are present, follow normal diagnostic procedures found in the PC/ED Manual.

Remove the upper intake and replace only the port gaskets (9H486) and isolator bolt assemblies (9S479). The new isolator bolt assemblies use a rubber material that is green in color, do not install the old isolator bolt assemblies with the black rubber material. Do not replace any other intake parts or gaskets.
While the upper intake manifold is removed, check the exhaust gas recirculation (EGR) orifices that are pressed into each primary port of the lower intake manifold. If any of the orifices are plugged with soot, clean and unplug them with a pick and solvent.

PART NUMBER PART NAME
1L3Z-9H486-AA Port Gasket
3F2Z-9S479-AA Isolator Bolt

Jan 13, 2010 | 2003 Ford F150 Regular Cab

2 Answers

P0302 #2 cylinder miss fire code. Replaced plugs and wires but at 40 mph runs very rough. Idles smoothly but not when put in gear.


I have a 1999 ford escort 2.0, its got a miss on cylinder 3 and 4. I changed the wires and the coil pack but its still missing. When scanned I get code p1506, p0303 and p0304

Jan 02, 2010 | 2000 Ford Windstar

2 Answers

2000 Lincoln Navigator with rough idling and service engine light


i had the same trouble, there is a rubber boot under the cover on the top of the motor, it is coming from the egr valve, takes about 5 mins to repair and less than 5 dollars.

Jul 21, 2009 | 2003 Lincoln Navigator

1 Answer

I have a Ford F250 Extended cab that started running rough and losing power this morning got Codes P0301 P0303 P1151 and P0171 What should i Do?


P0301 = Misfire cylinder #1P0303 = Misfire cylinder #2
P0171 = System too lean cylinder #1
Are you sure on the P1151 code? I am thinking this may be a P0151 which is O2 sensor related.
This looks like you have a fuel system related misfire. I would do a fuel injection cleaning service and then clear codes and see if the codes regenerate.

Jun 05, 2009 | 1997 Ford F250 SuperCab

2 Answers

98 E-250 Rough Idle; codes p0156,p1131,p1151,p0301,p0171,p0174+


po301 thru po306 all misfire codes cylinder 1-6 remove plugs and replace them..... set the plug gap first
i suggest u replace the wires also if they never been replaced all these misfire codes can set the others and one is for the oxygen sensor ( 02s or HO2S) CIRCUT MALFUNCTION do u know how to check wireing systems
do the tune up plugs (set gap) .052-.056 change the fuel filter also. clear the codes hows it run
this info is for 98 E-250 4.2Litre
what engine do u have 4.2L or 4.6L i know it is a v-6 by the codes

Dec 15, 2008 | 2003 Ford E250

2 Answers

Diagonostic trouble codes reported p0171 p0174 p0302 2001 Taurus, only reports P0171


P0171 is system too lean bank 1, P0174 is too lean bank 2, and 302 is misfire bank 1. Look for vacuum leaks. If you don't find them, put a vacuum gage on it can check. The P0171 is almost always a vacuum leak. If not other possibilities are front O2 sensor is too old and should be replaced (if mileage is greater than 100k then replace). Try injector cleaner. Misfires are usually bad spark plugs, but could possibly be caused by insufficient fuel. I've never had a car of mine in bad enough shape to have that error.

Sep 14, 2008 | 2001 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

449 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85104 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

21752 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...