BBB Industries online under Technical
Do the power door locks work for that door ? Does you vehicle have door courtesy lights , turn signals on the mirror ? If your vehicle has these other options an they work , you have power to the door . There is an electronic module inside the door ,called passenger door module ! where did you check for power at , the window switch ! These are computer controlled an you would only see a few volts when pushing the switch !
7
Does the window status data parameter change accordingly?
Go to Step 8
Go to Step 15
8
Does the window status data parameter change accordingly?
Go to Step 9
Go to Step 16
Operate the passenger front power window in the UP and DOWN directions from the master switch.
Does the passenger front power window operate properly from the master switch?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
Go to Step 5
4
Does the window lockout data parameter change state appropriately?
Go to Step 5
Go to Step 16
Your best bet is to take this to dealer or a ASE certified repair shop.
SOURCE: HAVE A 03 GMC SIERRA
I had the same problem in my wife's 2003 Yukon Denali. The power seats and passengers side window wouldn't work. Turned out to be a blown Buss Type fuse in the Underhood Fuse Block. It is the one marked MBEC 1 50amp. Hard to tell if the are blown so look very carefully. Should look like a hoop with two shiny solderlooking bubbles on either side. On my blown fuse, it caught my attention because it looked like the solder was missing and I had to look very closely to see the bottom of the "hoop" was open. They are very hard to remove and must be pulled straight up.
This type of fuse looks like a red square with a clear plastic top showing the fuse link under the plastic. On my vehicle it is on the top row second one from the left.
SOURCE: where is the 4x4 encoder motor sensor located on my 03 sierra
the encoder motor sensor is inside the encoder motor. the encoder is located at the transfer case. Remove the encoder and by part number 88962315 this is the sensor. you will have to retime the motor after
hope this helps
SOURCE: How to install passenger side glass on a 1997 gmc
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Remove the clips and screws securing the old window to the arm and slide it out through the top of the door (may need to be maneuvered out)
SOURCE: My Power window on my 2003 GMC Sierra 1500 Truck
if your main switch panel still works the passenger window and if door locks still work probaly bad window motor
SOURCE: wiring diagram 2003 GmC Sierra
I need wiring digram for GMC 2003 SIERRA . I have the left head light working fine but the right I have no power to it. I have checked the fuses and relaysand so far have not found and broken or frayed wires.
614 views
Usually answered in minutes!
×