Can the immobilizer or central locking be switched off in a Nissan Almeria 2001 car?

check your owners manual for the fuse listing and see if the fuse for the central locking has blown.

I had that problem the other day
Battery dead charged it fitted it started car central locking for other doors only let go after I drove the car down the road
So it might work for you as well

(door lock actuator)all doors have one in them, they weeken, and sometimes work to open, and some times to lock, or not at all. only fix is to replace each of them as they go out, usually cost abt 20 to 40 bucks a piece

Your problem is the interior light switch fuse has blown!which also serves the central locking system, located in the fuse box just above the drivers footwell (10amp) (well awkward). Replcace with one of the spare fuses supplied and all should be well. If your interior lights are not working (except boot light) this is a dead giveaway. Good luck.

2006 Nissan Pathfinder rear passanger doors don't open unless opened from insinde handle first. Then will open all the time until central locking is used then same problem occurs

Try squirting some WD40 into the lock and moving the key back and forth which may free it up.

Other possibility which works on many cars is to swap the driver and passenger locks around.

Please leave a positive feedback if you feel I have helped you, and feel free to come back to me if you require further assistance.

Thankyou

make sure the trunk is locked and the ignition is off.
the altima will not lock if the key is in the ignition.
it may think there is a key in the ignition because the switch is bad.

the problem lies in the drivers side operating switch for the central locking .this would involve removing the drivers side door handle and checking the switch mechanism thats built into the lock,havent done one o n this model only a opel astra ---but they are different from the opel although the car looks the same ,well similar pull it off have a go ,the key barrel must turn something so look for an internal switching or external switching and see if the spring is ok that returns the switch

with any BMW they have their problems, one is the central locking/immobilizer, the central locking is linked into the immobilizer and vice versa, the immobilizer takes it signal to disarm from the central locking and the ignition key ring. (chip in the key) if one of these starts to play up it has loads of consequences this being one of them. they all need to work together for the system to work properly. you would need to read the alarm and immobiliser codes using an ob2 tool that can detect them, and find the fault some problems it can be the drivers door sensor in the lock this is the main door as its drivers side and it controls all other doors on the central locking. if the switch is worn in any of it movements the system will not know the door has been opened, this does not work on the interior light as that is a switch in the door frame. the door lock is lock unlock and deadlock with key with remote fob its also arm disarm alarm and immobiliser. i have seen in some models there is a sensor auto lock so when you walk away with the key the doors lock automatically all lease parts work together. any one having a problem can cause no signal to be sent to the others in the system to start engine .