Have you checked your fuses headlights ,tail lights and brake lights are all on one fuse .then if the fuse is ok check to see if the bulbs are all ok.better still replace them.and then do the same as for the fuse for your wipers
SOURCE: 2001 Audi A4 Windshield Wiper Issues....Work on their own
The most likely cause of your symptoms is the wiper motor parking relay has become faulty, however there is a slim possibility the connections within your wiper switch could be an issue, but the relay would be my first and cheepest line of enquiry. Contact your local VAG dealer and expect to pay somewhere in the region of £15. Good luck
SOURCE: Audi A4 need to replace rear brake light on audi a4
Inside the boot is a plastic cap embeded in the boot liner. Remove the cap to reveal a screw. Undo the screw and the whole rear light cluster will come away in a sideways and not rearward direction to reveal all of the bulbs. Hope this helps.
SOURCE: windshield washer stopped working,wiper work fine
First check to make sure wiper fluid is full even if you just filled it they tend to get leaks, then make sure the pump is working. Have someone activate it while listening closely to pump. The main cause though is usually clogged or broken hoses, and even the part that sprays it out usually gets deposits that clog them. pull a line off see if it sprays out the hose if so, sometimes you can clean out the spryers with a paper clip or something that fits, however most the time you have to replace them.
SOURCE: Audi A4 tail lights come on at night and drain my battery
its the sensor in the brake pedal, happens mostly at cold nights since cold weather loosens up the pedal it causes the pedal to go down by itself if like you were braking, I used to roll up the matt and put it underneath the pedal and that would put pressure upwards while i was researching on how to do it myself found out is complicated and decided to take it to the mechanic for a 200$ fix.
SOURCE: 2004 Audi A4 headlight replacement
you have to loosen the whole headlight assembly to open the covers behind the lights to actually get to the bulbs. 4 screws, 2 are on the top of the assembly(phillips screws) the other two are hex and attach the bottom of the assembly to the car. somewhat difficult to see but look behind the assembly and down into the compartment and loosen the screws(they don't fully come out) just enough to pull the assembly out. open the black cover behind he low bean and there is the bulb
534 views
Usually answered in minutes!
×