How do you remove the lower center console on a 2000 Olds Intrique

Item Part Number Description 1 060024 Floor console armrest 2 06010 Floor console storage bin 3 04338D Floor console finish panel (front) 4 044D90 Floor console finish panel (center) 5 - Floor console cup holder screws (2 required) 6 13562 Floor console cup holder 7 - Floor console front screws (2 required) 8 - Floor console rear screws (3 required) 9 - Floor console nut 10 045A36 Floor console Removal and Installation

1. Position the seats as needed to remove the console.

1. Disconnect the battery. For additional information, refer to Section 414-01 .

1. Remove the floor console storage bin.
   1. Remove the 3 screws and the armrest.
   1. Remove the floor console storage bin screw.
   1. Remove the pin-type retainer.
   • Disonnect the electrical connectors.

1. Remove the floor console front finish panel.
   • Pull upward from the front of the trim panel to release the retainers.
   • Disconnect the electrical connectors.

1. Remove the floor console center finish panel.

1. If necessary, remove the 2 screws and the floor console cup holder.

1. Remove the 2 floor console front screws.

1. Remove the 3 floor console rear screws.
   • To install, tighten to 4 Nm (35 lb-in).

1. NOTE: Lift the console from the rear and slide it rearward to release the rear seat heater ducts from the instrument panel. Remove the nut and the floor console.
   • Disconnect the electrical connector.
   • To install, tighten to 8 Nm (71 lb-in ).

1. To install, reverse the removal procedure.