Where is the location of a camshaft position sensor on the engine of a I290 2007 isuzu truck
In what country? USA?
Makin GM Atlas engine
atlas LLV engine.
did you look at the engine photos at isuzu dot com yet.
that be free, google "OEM Isuzuk parts."
bingo , all parts in the car, shown.
gas engine. wiki facts.
The LLV (also called Vortec 2900) is a 2,921 cc (178.3 cu in straight-4 DOHC engine, with a 95.5 mm (3.76 in) bore and a 102 mm (4.0 in) stroke. It replaced the LK5 and produced 185 hp (138 kW) at 5600 rpm and 190 lb·ft (258 N·m) of torque at 2800 rpm. Engine redline is 6300 rpm.
first off runs off the cam so must be at the cam.
there are how many ends to cam, answer 2 per cam
just a casual look on all DOHC engines, and bingo the sensor is there, 3 wires or 4, usually
most cam sensors are HALL sensors. (electronic, not mag 2 wire)
here it is, shown in every auto store in USA>
cant find this? just by looking at cam ends. (all 4)
suzuki dot com online suxs. (sensor has no drawing page)
but my guess top right front of VC? (valve cover)
i bet now you can tell me.... pick a corner, and find it?
-Read in its repair manual.
Good luck
Mai
x2 , alldata.com has it. isuzu is mostly dead here. in USA, IE: cant just walk in and buy one at the missing dealerships.
as does mitchells.
as does the crummy chiltions.
or buy the book used on EBAY.
"ISUZU I290 service manual" and pray for one.
why post Easter egg hunts, ? and not post symptoms. why waste talent on that?
you guess ,the ask where stuff is.
post symptoms, first.
ok, so the scan tool shows DTC for the CMP sensor?
that it,
×
SOURCE: Low beam headlight is out on 2008 i290
Hi
Most probably you are seeing a lot of clutter in the bonnet to put your hand in and change it right? The best way sometimes is to unbolt the headlamp , move it out change the bulb and back in. But another way would typically be to remove the battery (and battery holder plastic box) or air box (whichever is in the way) and then you should be able to access the headlamp cover from behind. Anyways in both cases you should find a metal clip holding the bulb. Unclip the bulb whilst making sure that you dont touch the new bulb with you hands while putting it in. Press its metal clip in place again. and be sure to mount the plastic cover at the back properly so no water goes in the headlamp if its raining.
It was nice to help you :)
Best Regards
SOURCE: 2007 Isuzu i290 emergency brake
on the bottom, look at the teeth that lock the brake. they maybe rounded off or need a little help. without these teeth it will not lock brake on. they are on the bottom of emergency brake handle. have a good one !!
SOURCE: where do i locate the
it is located on the inner rear section of the left hand head (left side of vehicle) under inlet manifold dont need to remove inlet manifold
and connector must face rearwards to work correctly
942 views
Usually answered in minutes!
×