Double posted. by OP
the 1.8L , is on the left rear of cam, it a twin cam engine, DOHC.
face the engines, front pulley, point to right rear of cam shaft. bingo. CMP
on the 1999, In usa, any scan tool will till you its bad. for sure.
P03xx codes. 340 are cmp failure.
can be seen driving, or parked, engine running, or even CRANKING.
if the scan tool shows no, errors with it, it's not bad.
the PCM will show even 1 missing pulse in 10. (drop outs)
fact. (covered in the FSM book)
here is the parts page.
page 21 shows the mount.
http://www.fixkick.com/engine/20Liter/html/index.html
SOURCE: 1998 528i bmw cam shaft sensor location
hope this helps .
http://picasaweb.google.com/mmm635/CamshaftPositionSensorsCamshaftPulseGeneratorsAsBMWCallsIt#
not the same year but should be same place.
SOURCE: Cam Shaft Position Sensor 1998 Saturn SL
Have a look at this link, scroll to your engine & click on picture to expand for better view.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528017e904
SOURCE: Suzuki Baleno (esteem) 1999. Engine Idle RPM not stable
you probably need to check the butterfly. its the compinent that controls how much air goes into the engine if it is weared than in idle state air leaks into the engine sometime more sometimes less and cause fluctuations in rpm
secondly there is a rpm switch which controls the rpm you can replace that switch and check
SOURCE: Where are the oxygen sensors located on the 1998
the O2 sensor is located just before your catalytic converter. The MAF sensor is located on your air intake pipe just after the filter
SOURCE: 1999 suzuki esteem fuel filter location
This is a Baleno in our market (Australia) and the G16B 1.6 EFI SOHC 16v has the fuel filter bolted to the firewall in the engine bay. This fuel system will be under pressure even after the engine has been off for a long period of time.
934 views
Usually answered in minutes!
×