SOURCE: Flashing Check Engine Light 99 Camry
light flashes when comp. picks up a skip pull code and it will be po300 random miss p0301 p0302 p0303 p0304 all are for that # cyl that has the miss best bet change wires and plugs check for oil on wire to plug end in spark plug hole leaking valve cover gasket or spark plug tubes...
SOURCE: 99 Hyundai Automatic hesitates to move & check-engine light just
It is most probably your knock sensor that activated the check engine light.
1.By start off, I presume it means to take off in gear (the vehicle moving).
Start the vehicle and let it idle for about a minute, then with the engine still running pull out the dipstick for the transmission and check your oil level. notice the correct oil level is obtained by looking at the dipstick angled down and follow the solid oil mark from the bottom on the stick to where it is only partially covered in oil, this is your mark.
If it is not on the min. mark or the lowest mark at-least, your ATF oil is way to low and that is why it is taking a long time to start off and seems to be jerking.
2. If the above is not your problem, ask your self when last was my vehicle serviced, spark plugs ect.
SOURCE: PO441 check engine light on v6 99 camry with
There's no most likely culprit... this code may mean that one of more of the following has occurred:
However, this code is tricky to diagnose. Here are some solutions you can try:
SOURCE: 99 TOYOTA CAMRY CHECK ENGINE
You are going to have to get your car plugged in to a code reader and you will then be able to identify fault code causing check engine light illumination,
You have a ground issue.Current from another circuit is running through the lights to get to ground. this causes them to burn out quickly.You need to do a real detailed visual check.A good component wiring diagram and component locator is a requirement here.
31 views
Usually answered in minutes!
×